We report the detailed analysis of thermoluminescence (TL) glow curves and the evaluation of kinetic parameters of Sm3+-incorporated BaSi2O5.The effect of various heating rates on TL kinetics and glow peak temperatures of Sm3+-doped BaSi2O5 phosphors exposed to beta particle irradiation at room temperature are investigated. The glow curve of the phosphor exposed to β-irradiation consists of two main peaks with maxima at about 91°C and 193°C and exhibits good linearity between 1 and 10 Gy. The activation energies and frequency factors of trap centers involved in the TL emission were calculated from the TL glow curve of the sample by means of variable heating rate (VHR), repeated initial rise (RIR), and computerized glow-curve deconvolution (CGCD). Analysis of the main dosimetric peak techniques indicate that activation energies (E) and pre-exponential factor (s) vary between 0.93 and 1.72 eV, 1010 and 1013 s−1. It is found that the temperature of the glow peaks shifts toward the higher temperatures and the TL intensity smoothly decreases as the heating rate increases. The behavior of the TL intensities and glow peak temperatures as a function of the heating rate are discussed with regards to thermal quenching.
The existence of hazardous, dangerous and non-biodegradable aromatic organic contaminants in the environment poses great challenges to human health and ecosystems. This research studied the influence of codoping by Fe/Sb ions on the photodegradation activity of nanocrystalline CuO towards Congo red (CR) dye under solar irradiation. Nanocrystalline samples of pure, (1% Fe + 1% Sb) and (3% Fe + 3% Sb) co-doped CuO were produced via the coprecipitation method. X-ray diffraction (XRD) results confirmed the single monoclinic phase with C2/c space group for the pure, (1% Fe + 1% Sb) and (3% Fe + 3% Sb) co-doped CuO samples, with crystalline sizes within 33–58 nm. The well-known Kubelka–Munk method revealed that the band gap energies of pure, (1% Fe + 1% Sb) and (3% Fe + 3% Sb) co-doped CuO samples were 1.48, 1.5 and 1.49 eV, respectively. X-ray photoelectron analysis of Fe/Sb co-doped CuO powder verified that Cu, O, Fe and Sb constituents are in the +2, −2, +3 and +3 oxidation states, respectively. Morphological study showed that the pure CuO and (1% Fe + 1% Sb) co-doped CuO samples exhibited a regular distribution of particle size and shape, while the (1% Fe + 1% Sb) co-doped CuO particles displayed large grains with irregular morphology. For environmental remediation, photocatalytic tests revealed that the Fe/Sb co-doping considerably boosted the degradation rate of Congo red dye under solar irradiation. The (1% Fe + 1% Sb) co-doped CuO catalyst was the most effective photocatalyst, with a measured efficiency of 97% after 20 min of solar irradiation. Thus, Fe/Sb co-doping is a promising strategy for the usage of nanostructured CuO powder in wastewater treatment.