11 June 2007 in Applied Physics Letters
The electron lifetime has been measured by time-resolved differential transmission experiments in heavily carbon-doped -type InGaAs and GaAsSb, grown lattice matched on InP by molecular beam epitaxy. It is found inversely proportional to the square of the doping in both alloys, a result typical of Auger recombination dominated processes. It is shown that the electron lifetime is almost twice larger in GaAsSb than in InGaAs for large -type doping, thus confirming that GaAsSb is a strong contender for the base material of double heterostructure bipolar transistors on InP.
15 August 2010 in Journal of Applied Physics
Electronic properties of the Al0.56In0.44Sb/Ga0.5In0.5Sb heterostructure grown by molecular beam epitaxy are investigated. We measure by means of x-ray photoemission spectroscopy, photoluminescence, and Hall effect measurements the key parameters involved in the achievement of a high speed and very low power consumption field effect transistor: conduction and valence band offsets, energy gaps of channel and barrier materials, electron effective mass, and density of states in the channel. We observe the influence of the quantum well thickness on the electron Hall mobility and sheet carrier density. A type I heterostructure exhibiting a room temperature electron mobility of 25 000 cm2 V−1 s−1 with a sheet carrier density of 1.5×1012 cm−2 is demonstrated for the widest channel. We show that the thickness of the channel influences both Hall density and mobility through a multisubband occupancy. We discuss about the scattering mechanisms limiting the mobility in the second subband.
30 July 2021 in 2D Materials
Hexagonal boron nitride (h-BN) was synthesized by molecular beam epitaxy on polycrystalline Ni foils using borazine (B 3 N 3 H 6 ) as precursor. Our photoemission analysis shows that several components of boron and nitrogen are detected, suggesting the complex nature of the bonds noticeably at the h-BN/Ni interface. The BN thickness was estimated by photoemission and the BN distribution by time-of-flight secondary ion mass spectroscopy. Due to the catalytic effect of the Ni substrate, this thickness is self-limited in the range 1–2 layers regardless of the borazine dose. A spatially resolved photoemission study was carried out before and after transfer of the h-BN on a Si substrate. It shows that a strong electronic coupling exists at the interface between h-BN and polycrystalline Ni, not only for (111) grains, which disappears after transfer on Si. In addition, we highlight the importance of detecting π plasmons in the photoemission spectra to confirm the hexagonal nature of BN.
21 June 2024 in 2D Materials
2D material epitaxy offers the promise of new 2D/2D and 2D/3D heterostructures with their own specific electronic and optical properties. In this work, we demonstrate the epitaxial growth of few layers WSe2 on GaP(111)B by molecular beam epitaxy. Using a combination of experimental techniques, we emphasize the role of the growth temperature and of a subsequent annealing of the grown layers under a selenium flux on the polytype formed and on its structural and morphological properties. We show that a low growth temperature promotes the formation of the 1T′ and 3R phases depending on the layer thickness whereas a higher growth temperature favours the stable 2H phase. The resulting layers exhibit clear epitaxial relationships with the GaP(111)B substrate with an optimum grain disorientation and mean size of 1.1° and around 30 nm respectively for the 2H phase. Bilayer 2H WSe2/GaP(111)B heterostructures exhibit a staggered type II band alignment and p-doped character of the epi-layer on both p and n-type GaP substrates. This first realisation of stable p-type WSe2 epi-layer on a large-area GaP(111)B substrate paves the way to new 2D/3D heterostructures with great interests in nanoelectronic and optoelectronic applications, especially in the development of new 2D-material p-n junctions.
4 November 2022 in Nanotechnology
2D boron nitride (2D-BN) was synthesized by gas-source molecular beam epitaxy on polycrystalline and monocrystalline Ni substrates using gaseous borazine and active nitrogen generated by a remote plasma source. The excess of nitrogen atoms allows to overcome the thickness self-limitation active on Ni when using borazine alone. The nucleation density and the shape of the 2D-BN domains are clearly related to the Ni substrate preparation and to the growth parameters. Based on spatially-resolved photoemission spectroscopy and on the detection of the π plasmon peak, we discuss the origin of the N1s and B1s components and their relationship with an electronic coupling at the interface. After optimization of the growth parameters, a full 2D-BN coverage is obtained, although the material thickness is not evenly distributed. The 2D-BN presents a granular structure on (111) oriented Ni grains, showing a rather poor cristallographic quality. On the contrary, high quality 2D-BN is found on (101) and (001) Ni grains, where triangular islands are observed whose lateral size is limited to ∼20 μm.
24 July 2023 in Nanotechnology
The growth of two dimensional sp2-bonded boron nitride (2D-BN) was studied in a plasma-assisted molecular beam epitaxy set-up, using independent boron and nitrogen sources. We studied the growth conditions on polycrystalline Ni foils: B and N respective fluxes, growth temperature and time, which are influencing the surface morphology, stoichiometry and the 2D-BN domain size. Using a B/N precursor flux ratio ≫1 yields films with incorporated boron largely in excess and intermixed with 2D-BN. On the contrary, precursor flux ratios from moderately B-rich to moderately N-rich leads to stoichiometric 2D-BN. The optimum growth temperature is found to be 900 °C, a temperature for which the crystallographic quality is improved compared to lower temperatures thanks to the increased adatom surface mobility although a partial sublimation of BN occurs. Increasing the growth time under the optimized settings shows that the growth does not occur in a layer-by-layer mode, but rather by stacking BN domains on top of each other with a rather slow lateral extension of the domains.