6 August 2015 in Procedia Engineering
The paper considers the peculiarities of structure forming in composite materials on the basis of polytetrafluoroethylene (PTFE) containing metals or polyimide while explosive processing of powder compositions by the ring shock front. The stepwise change of the structure in the center of pressing, accompanied by occurrence of nanodimensional phases, change of fine structure and increase of microhardness is determined. It is achieved under a certain combination of the explosive's parameters and powder composition's porosity.
1 February 2009 in Nanotechnologies in Russia
This work is aimed at preparing polymer nanocomposites or, in the case of high-filled composites with a metal content of over 50%, organometallic nanoalloys by explosive processing of powder...
9 November 2016 in Chemical and Petroleum Engineering
30 November 2018 in IOP Conference Series: Materials Science and Engineering
Metal filled composite materials on the basis of polytetrafluoroethylene (PTFE) are widely used in tribotechnical units of different equipment. Amongst the metal fillers for PTFE, aluminum is the most perspective, it has high thermal conductivity and low density, which is relevant for the aircraft industry. Due to low adhesion of PTFE to metals, the thermal conductivity and strength properties of these CM are low, so it is perspective to use explosive pressing (EP) which provides the conditions for an increase in physical-chemical interaction between CM components. The work researches the influence of EP on the structure, thermal expansion and thermal conductivity of composite materials on the basis of PTFE containing 10 and 30% vol. of aluminum. It has been established that EP, as well as sintering in a closed volume, contributes to a decrease in thermal expansion and an increase in the thermal conductivity of composite materials, which is connected to structural changes accompanied by an intensification of adhesive interfacial interaction. At the same time, with an increase in aluminum concentration, the efficiency of EP increases due to the increase in the number of contacts between metal particles, as well as the occurrence of an interphase zone, with peculiar properties.
1 February 2016 in IOP Conference Series: Materials Science and Engineering
The paper considers changes of the structure and thermomechanical properties of polytetrafluoroethylene pressing after the explosive treatment depending on the thickness of the pressing. Structural changes and defects in samples, preserved even after sintering, were detected.
1 March 2015 in Chemical and Petroleum Engineering