1 March 2022 in Journal of the Electrochemical Society
A novel bi-layer coating composed of a tantalum base layer with an Indium Tin Oxide (ITO) top layer was applied to titanium substrates. Samples were polarized ex situ in a parameter study, where the pH, potential and temperature of the electrolyte was altered, as well as the polarization duration. The Interfacial Contact Resistance (ICR) after polarization showed an increase with time for the first 24 h, then stabilized at approx. 30 mΩ cm2. Minor variations were seen in the ICR after polarization at 1.4 VRHE and 2.0 VRHE, but after polarization at 2.5 VRHE and 2.6 VRHE, the ICR increased to 102 mΩ cm2 and 503 mΩ cm2, respectively. X-ray photoelectron spectroscopy (XPS) analysis revealed that the oxygen to metal ratio on the Tantalum- Indium Tin Oxide (Ta-ITO) coated sample surfaces increased with increasing polarization potential. The surfaces of the samples polarized at 2.5 VRHE and 2.6 VRHE showed lower concentrations of oxygen vacancies, an increase in hydroxides and a decrease in metallic character compared to the non-coated and baseline samples. ITO proved to be a promising candidate for use as coating on BiPolar Plates (BPPs) in Proton Exchange Membrane Water Electrolyzers (PEMWEs).
7 August 2019 in Journal of the Electrochemical Society
17 March 2022 in Journal of Power Sources
3 August 2022 in IEEE Transactions on Transportation Electrification
Bolted busbar connections are a simple and versatile connection method used in battery systems. Copper busbars are widely used for such bolted connections; however, aluminum offers the potential to save weight and cost. To date, the reliability of aluminum connections dimensioned for battery systems and the vulnerability to corrosion accelerants is not established. In this study, bolted aluminum connections were tested under operational and environmental conditions applicable to battery systems. Four bolted configurations (AA1070 and AA6101, with nickel plating or brushed contact surfaces) were exposed to corrosive environments and current-induced thermal cycling. Nickel plating provided a robust contact interface that maintained stable resistance over 6000 cycles across three temperature levels. The nickel plating’s electrical performance was unaffected by the corrosive environments, including humidity, salt mist, and hydrogen sulfide exposure. The brushed aluminum configurations produced connections with greater contact resistance variation and achieving a joint performance factor < 1.5 was critical for long-term reliability. The growing appeal of aluminum in battery systems requires verification methods capable of assessing new contact configurations. Currently, corrosion test environments for evaluating aluminum contacts are lacking in the literature. This study provides insights into the performance of bolted aluminum configurations dimensioned for battery systems and provides methodology for accelerated verification of new configurations.
3 December 2025 in Journal of Power Sources