28 June 2018 in Journal of Intelligent Material Systems and Structures
A three-dimensional adaptive shock control bump made of shape memory alloy is proposed for transonic wings. The methodology to adaptively change the configuration of the airfoil using the shape memory alloy bump to reduce the shock strength and wave drag is numerically demonstrated using an airfoil RAE2822. The shape memory alloy bump is trained to have a flat initial shape with certain initial strain and can swell up when thermally activated. Boyd–Lagoudas phenomenological model is implemented in finite element method and used to compute the two-dimensional profile and the height of the shape memory alloy bump during thermal activation. The results show that the shape memory alloy bump can generate a considerable deflection due to the reverse phase transformation when thermally activated. The dependence of aerodynamic characteristics of the wing on the height of the shape memory alloy bump and the angle of attack is investigated using computational fluid dynamics method. The results show that there is an optimal bump height for a given angle of attack and the bump with a given height is effective only in certain range of angle of attack. Optimization of bump height and the corresponding driving temperature are carried out under variable angles of attack with the lift-to-drag ratio as the objective function.
23 August 2021 in Journal of Intelligent Material Systems and Structures
A shape memory alloy (SMA) with composition of Ni50.1Ti49.9 (at. %) was used for fabrication of a 3-D bump structure intended for use as an active shock control bump (SCB) into a transonic wing. This kind of bump is a variable-geometry structure designed to reduce the drag induced by shock wave ensure wing’s aerodynamic performance over the entire range of operating conditions. To meet this target, the SMA bump requires to exhibit two-way shape memory effect (TWSME) so that it can yield continuous shape change by properly changing the driving temperature. Result from differential scanning calorimetry was first presented to provide material’s phase transformation temperatures. To obtain the TWSME, a thermo-mechanical training procedure was proposed and a set of training devices were designed for training SMA bump. The SMA bump in this paper is trained to have a relatively flat shape in high temperature and can swell up when cooling. After more than 80 times training, the TWSME of the material tends to be stable. Then the thermo-mechanical responses of the SMA bump which is subjected to about 100 times training was tested. The result shows that the trained SMA bump can generate about 1.2 mm maximum recoverable deformation during martensitic transformation, which is about 3% of the ratio of the deformation region. Finally, the influence of external load on the thermo-mechanical response of the trained SMA bump were also studied.