1 October 2018 in Measurement
1 March 2018 in Journal of Orthopaedic Science
3 April 2018 in Journal of Tribology
Tribological properties, i.e., wear rate, coefficient of friction (COF), and roughness of worn surfaces of an Al-Mg-Zn-Cu alloy and its composite reinforced with 20 wt % Al2O3 particles developed by stir-casting method have been studied and compared under two-body abrasion considering four independent control factors, i.e., load, abrasive grit size, sliding distance, and velocity each at three different levels. Design of test conditions and analyses of output responses have been performed employing standard Taguchi L27 orthogonal array, signal-to-noise ratio, analysis of variance technique, and regression method. Irrespective of wear conditions, composite exhibits lower wear rate and reduced COF with reference to base alloy owing to the load bearing ability and better wear resistance capability of Al2O3 particles. Roughness of worn surfaces of composite is, however, found to be higher over base alloy due to nonuniform abrasion in case of composite that generates the protruded Al2O3 particles on contact surfaces as the surrounding soft matrix is easily removed. For all three tribo-responses of both materials, the most influential factor is identified as grit size followed by load and then, grit size-load interaction except for the roughness of worn surfaces where the influence of sliding distance is also considerable. Linear regression models with excellent predictability have been developed for all tribo-characteristics separately for base alloy and composite. The predominant mechanisms of abrasion are identified as plowing and microcutting for base alloy, but delamination for composite.
16 January 2019 in Journal of Tribology
Al–Zn–Mg–Cu matrix composites reinforced with (0–20 wt %) Al2O3 particles have been manufactured by enhanced stir casting technique. Microstructural characterization of cast composites by optical, field emission scanning electron microscope (FESEM), energy dispersive X-ray (EDS) and X-ray diffraction (XRD) reveals homogeneous distribution of reinforcements in Al-alloy matrix with MgZn2 plus Al2CuMg intermetallics. With increasing particle content, hardness of composite rises considerably in spite of marginal rise in porosity. Tribological performance under two-body abrasion has been studied considering central composite design (CCD) apart from identification of mechanisms of wear via characterizations of abraded surfaces and debris. Composites exhibit significantly reduced wear rate and coefficient of friction (COF) irrespective of test conditions, since mechanisms of abrasion are observed to change from microplowing and microcutting in unreinforced alloy to mainly delamination with limited microplowing in composites. Effects of four independent factors (reinforcement content, load, abrasive grit size, and sliding distance) on wear behavior have been evaluated using response surface-based analysis of variance (ANOVA) technique. Dominant factors on both wear rate and COF are identified as reinforcement content followed by grit size and load. Combined optimization of wear rate and COF employing multiresponse optimization technique with desirability approach as well as regression models of individual responses have been developed, and their adequacies are validated by confirmatory tests. The developed mathematical models provide further insight on the complex interactions among wear performances of the selected materials and variables of abrasive system. The optimum amount of reinforcement is identified at around 15 wt % for achieving the lowest values of both wear rate and COF.
1 January 2019 in Biocybernetics and Biomedical Engineering
1 January 2004 in Journal of Sound and Vibration