29 December 2017 in Studia Universitatis Babeș-Bolyai Chemia
HAP powder of a low crystallinity and rather large specific surface area was synthesized by an environmentally friendly, cost-effective precipitation method, and characterized by XRD, FTIR, and BET isotherms. TEM and AFM are used to envisage the surface of HAP nano particles, showing a high porosity of this ceramic powder. It was used for the removal of metals (Al, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn) from mine wastewater. Metal contents in the initial and treated samples were quantified by inductively coupled plasma atomic emission spectrometry and high-resolution continuum source atomic absorption spectrometry. An efficient removal of all metals was ensured by using HAP. The increase of Ca2+ ions content in the treated water suggests an ion exchange mechanism.
29 September 2017 in Studia Universitatis Babeș-Bolyai Chemia
This paper focuses on the obtaining of carboxylate precursors through the redox reaction of cobalt nitrate and ethylene glycol, in different stoechiometric ratios, as well as the decomposition of precursors into cobalt oxides. The influence of the NO3−:C2H6O2 stoichiometric ratio on the formation of the precursors is studied through thermal analysis, FTIR spectroscopy and acido-basic analysis (conductometric/potentiometric titrimetry). Phase analysis by XRD and FTIR of the powders obtained at the decomposition of the precursors at 400°C has evidenced the formation of CoO for a high NO3-:C2H6O2 synthesis ratio and of Co3O4 for a low NO3−:C2H6O2 ratio. The Scherrer equation and scanning electron microscopy (SEM) were used to determine the dimensions of the nanoparticles obtained.
29 December 2017 in Studia Universitatis Babeș-Bolyai Chemia
Endodontic cement based on calcium silicate has been the focus of many studies. However, the quality of resulted endodontic cement needs improvement. This paper focuses on endodontic cement obtained from Portland cement enriched with two types of hydroxyapatite, simple and doped with 5% Zn. Hydroxyapatites were synthesized using a wet precipitation method and investigated by X-ray diffraction, FTIR, TEM and AFM. From a structural point of view, both hydroxyapatites were obtained in a single crystalline phase, containing particles in the nanometric range, as judged by XRD, TEM and AFM. FTIR analysis presents O-H and P-O bands specific to those in pure hydroxyapatite, confirming a hydroxyapatite lattice in both materials. Several experimental compositions of commercial Portland cement mixed with hydroxyapatite were prepared. The influence of stoichiometric and Zn doped hydroxyapatite on the resulted endodontic cement was observed in the setting time. The setting time for both cements decreased exponentially at both temperatures (22 ⁰C and 37 ⁰C). The normal consistency water remains constant for all experimented slurries.
29 December 2017 in Studia Universitatis Babeș-Bolyai Chemia
This paper focuses on a comparative analysis between the carboxylate precursors obtained through the redox reaction between cobalt nitrate and 1,2-propanediol, and cobalt nitrate with 1,3-propanediol, respectively. The formation of the lactate and malonate precursors was followed with thermal analysis, FTIR spectrometry and acido-basic analysis (conductometric/ potentiometric titrimetry). The decomposition of the carboxylate precursors and the formation rate of cobalt oxides were observed by X-ray diffractometry and FTIR spectrometry, following advanced thermal treatments at 500°C, 800°C and 1000°C, with a pretreatment at 300°C. The differences between the two positional diol isomers are comparatively discussed.