We report the dc and RF performance of ScAlN/GaN high-electron-mobility transistors (HEMTs). The ScAlN/GaN material was epitaxially grown onto a GaN template on a 4-in 4H-SiC substrate by molecular beam epitaxy. The sheet resistance was measured to be 236 ± 4 $\Omega /\square $ across the wafer by the transfer length measurement. Selective area regrowth of highly doped GaN was implemented to reduce contact resistance ( ${R}_{C}$ ) as low as 0.1 $\Omega \cdot \textsf {mm}$ . HEMT devices with $\textsf {2}\times \textsf {150}\,\,\mu \text{m}$ gate width and 140-nm T-gate process show a maximum current density and a transconductance of 2.4 A/mm and 0.67 S/mm, respectively. The extrinsic small-signal gain was measured as a function of drain bias and gate length with extrinsic cutoff frequency and maximum oscillation frequency reported up to 88 and 91 GHz, respectively.
We report the RF power results of Sc(Al,Ga)N/GaN high electron mobility transistors (HEMTs). We show dc, small-signal RF and load-pull performance at 30 GHz with two barrier alloys-a ternary of ScAlN and a quaternary of ScAlGaN. The active layers are grown by molecular beam epitaxy on a GaN-on-SiC template. The Sc(Al,Ga)N HEMTs with 120 nm gate length achieve transconductance >700 mS/mm and >70 GHz cutoff frequency. The quaternary ScAlGaN sample shows reduced current collapse during pulsed I-V and load-pull characterization. The ScAlGaN HEMT delivers 5.77 W/mm output power (VD = 20 V) and 47% power-added efficiency (VD = 15 V) when tuned for maximum power and efficiency, respectively.
24 January 2024 in IEEE Transactions on Electron Devices
High temperature (HT) electronics applications will require the development of a broad range of devices made using different materials. Among these devices, high-electron mobility transistors (HEMTs) made with GaN and its alloys are attractive for high-power radio frequency (RF) applications. In this manuscript, we tested AlGaN/GaN HEMT devices having $\sim$ 140-nm gate length at different temperatures up to 500 $^{\circ}$ C. Devices were fabricated using Air Force Research Laboratory’s (AFRL’s) 140-nm T -gate process technology. The performance degradation measured in different devices was analyzed by considering changes in different device parameters and by using appropriate device physics. Cross-sectional materials characterization using scanning transmission electron microscopy (STEM) and electron energy loss spectroscopy (EELS) was performed to understand the origin of performance degradation. This understanding will allow us to design a sub- $\mu$ m GaN-based process technology compatible with HT RF applications.
22 November 2019 in IEEE Transactions on Electron Devices
β -Ga₂O₃ thin-channel MOSFETs were evaluated using both dc and pulsed I-V measurements. The reported pulsed I-V technique was used to study self-heating effects in the MOSFET channel. The device was analyzed over a large temperature range of 23 °C-200 °C. A relationship between dissipated power and channel temperature was established, and it was found that the MOSFET channel was heating up to 208 °C when dissipating 2.5 W/mm of power. The thermal resistance of the channel was found to be 73 °C-mm/W. The results are supported with the experimental Raman nanothermography and thermal simulations and are in reasonable agreement with pulsed I-V findings. The high thermal resistance underpins the importance of optimizing thermal management in future Ga₂O₃ devices.
We evaluate the accuracy of small-signal on-wafer device characterization in the sub-THz frequency range when employing conventional and advanced calibration methods with state-of-the-art design of on-chip standards. We report that major discrepancies resulting from an interlaboratory comparison experiment are mainly attributed to the influence of microwave probes. When performing conventional multiline thru-reflect-line (mTRL) calibrations with six different models of probe from 140 to 325 GHz, we observe significant variations in the measured scattering-parameters (S-parameters) and show that probes made by various manufacturers induce disparate crosstalk responses that vary between -70 and -15 dB on open–open standards. After applying a crosstalk correction approach as a second-tier calibration, we obtain significantly better agreement between the RF performance of the same heterojunction bipolar transistor (HBT) measured with two different probe models. While the difference between the maximum stable gain (MSG) reaches 1.8 dB at 210 GHz after applying a conventional mTRL calibration, we reduce the error to ~0.5 dB after crosstalk correction. This study shows that crosstalk correction methods must be implemented in the sub-THz frequency range to accurately estimate the RF performance of active devices and circuits.