In this paper, microspheres were prepared by oil-in-water (o/w) emulsion solvent evaporation method. Biodegradable polymer such as blend of poly (lactic acid) (PLA) and poly(ɛ-caprolactone) (PCL) with certain compositions and characteristics was used to prepare the microspheres with poly(vinyl alcohol) (PVA) as an emulsifier. This study observed the microspheres particle’s size distribution at various concentrations of PVA (1%, 1.5%, 2%, and 2.5% PVA). The PVA volume variations effects during the process (50, 100, 150, 200, and 250mL) were also observed. The blend of PLA and PCL is formed only by physical interaction between them. This can be seen from the FTIR spectrum which shows both PLA and PCL component. The microspheres physical size and appearance were observed by optical microscope (MO). The overall results of this study showed that the formula which used 50–150mL of 2.5% polyvinyl alcohol produced the microspheres with the most uniform size distribution
In this research, three modified chitosan-based hydrogels are synthesized, i.e., a crosslinked chitosan hydrogel and semi- and fully-interpenetrating polymer network (IPN) chitosan hydrogels fabricated using poly(N-vinyl-pyrrolidone). A non-modified chitosan hydrogel was also synthesized as a control. These samples were compared regarding their swelling behavior and mechanical properties. The hydrogels were characterized by Fourier Transform Infrared (FTIR) analysis and microscopy observations. The effect of crosslinking on the swelling capacity and on the swelling kinetics were evaluated in distilled water, simulated gastric fluid (SGF), and simulated intestinal fluid (SIF) at 37 °C, and the data were interpreted using various kinetic models. Finally, the mechanical properties were evaluated based on the tensile strength using a universal tensile testing machine. The results revealed that the swelling process conformed to the Schott model (pseudo-second-order kinetics), with Fickian diffusion as the diffusion mechanism type. The hydrogels all showed similar trends in their swelling kinetics. However, the full-IPN hydrogel exhibited the lowest equilibrium swelling capacity and the highest swelling rate. The mechanical test results indicate that the crosslinking model affects the resulting tensile strength.
The main problems in synthesis polymer clay nanocomposites (PCNs) with nanoclay filler is the nanoclay was not compatible to most of polymer matrix due to its hydrophilicity which is often causes agglomeration of the nanoclay in the polymer matrix. Surface modification of nanoclay for a good compatibility with polymer matrix is the most important step to achieve homogenous dispersion of clay platelets in polymers. Modification of nanoclay montmorillonite (MMT) can be done through conventional ion exchange method using cationic surfactants. Montmorillonite (MMT) was modified with several cationic surfactants based on its cationic exchange capacity (CEC). The effect of chemical composition of modified MMT on the basal spacing were evaluated by small angle x-ray diffraction (SAXS), the highest basal spacing expanded from 1.21 nm to 2.00 nm showed the intercalation of the surfactant ion into the intergalerry of sodium montmorillonite clay layers which caused increasing of surface area and porosity. FTIR spectra shows the successful of inserting alkyl groups from cationic surfactant in interlayer space of montmorillonite. Organophilization reduces the energy of sodium montmorillonite and improves its compatibility with organic polymer. Dispersion analysis and contact angle results shown the surface wettability of montmorillonite was enhanced from hydrophilic to organophilic and resulting good solubility in monomer phase.
17 September 1992 in European Journal of Organic Chemistry