Mega-earthquakes go the flat way: Megathrust faults in subduction zones cause large and damaging earthquakes. Bletery et al. argue that certain geometric features of the subduction zones relate to earthquake size. The key parameter is the curvature of the megathrust. Larger earthquakes occur where the subducting slab is flatter, providing a rough metric for estimating where mega-earthquakes may occur in the future. Science , this issue p. 1027
The existence of an observable precursory phase of slip on the fault before large earthquakes has been debated for decades. Although observations preceding several large earthquakes have been proposed as possible indicators of precursory slip, these observations do not directly precede earthquakes, are not seen before most events, and are also commonly observed without being followed by earthquakes. We conducted a global search for short-term precursory slip in GPS data. We summed the displacements measured by 3026 high-rate GPS time series—projected onto the directions expected from precursory slip at the hypocenter—during 48 hours before 90 (moment magnitude ≥7) earthquakes. Our approach reveals a ≈2-hour-long exponential acceleration of slip before the ruptures, suggesting that large earthquakes start with a precursory phase of slip, which improvements in measurement precision and density could more effectively detect and possibly monitor.
6 September 2014 in Journal of Geophysical Research: Solid Earth
The 11 March 2011 Mw9.0 Tohoku‐Oki earthquake was recorded by an exceptionally large amount of diverse data offering a unique opportunity to investigate the details of this major megathrust rupture. Many studies have taken advantage of the very dense Japanese onland strong motion, broadband, and continuous GPS networks in this sense. But resolution tests and the variability in the proposed solutions have highlighted the difficulty to uniquely resolve the slip distribution from these networks, relatively distant from the source region, and with limited azimuthal coverage. In this context, we present a finite fault slip joint inversion including an extended amount of complementary data (teleseismic, strong motion, high‐rate GPS, static GPS, seafloor geodesy, and tsunami records) in an attempt to reconcile them into a single better resolved model. The inversion reveals a patchy slip distribution with large slip (up to 64 m) mostly located updip of the hypocenter and near the trench. We observe that most slip is imaged in a region where almost no earthquake was recorded before the main shock and around which intense interplate seismicity is observed afterward. At a smaller scale, the largest slip pattern is imaged just updip of an important normal fault coseismically activated. This normal fault has been shown to be the mark of very low dynamic friction allowing extremely large slip to propagate up to the free surface. The spatial relationship between this normal fault and our slip distribution strengthens its key role in the rupture process of the Tohoku‐Oki earthquake.
Large earthquakes are the product of elastic stress that has accumulated over decades to centuries along segments of active faults. Assuming an elastic crust, one can roughly estimate the location and rate of accumulation of elastic stress. However, this general framework does not account for inelastic, irrecoverable deformation, which results in large‐scale topography. We do not know over which part of the earthquake cycle such deformation occurs. Using InSAR and GNSS measurements, we report on a potential correlation between long‐term, inelastic vertical rate and short‐term, interseismic vertical rate in northern Chile. Approximately 4% to 8% of the geodetically derived interseismic vertical rates translate into permanent deformation, suggesting that topography of the forearc builds up during the interseismic period. This observation provides a quantitative basis for an improved understanding of the interplay between short‐term and long‐term dynamics along convergent plate boundaries.
On 14 August 2021, the moment magnitude (Mw) 7.2 Nippes earthquake in Haiti occurred within the same fault zone as its devastating 2010Mw7.0 predecessor, but struck the country when field access was limited by insecurity and conventional seismometers from the national network were inoperative. A network of citizen seismometers installed in 2019 provided near-field data critical to rapidly understand the mechanism of the mainshock and monitor its aftershock sequence. Their real-time data defined two aftershock clusters that coincide with two areas of coseismic slip derived from inversions of conventional seismological and geodetic data. Machine learning applied to data from the citizen seismometer closest to the mainshock allows us to forecast aftershocks as accurately as with the network-derived catalog. This shows the utility of citizen science contributing to our understanding of a major earthquake.
The North Anatolian Fault (NAF) has produced numerous major earthquakes. After decades of quiescence, the Mw 6.8 Elazığ earthquake (24 January 2020) has recently reminded us that the East Anatolian Fault (EAF) is also capable of producing significant earthquakes. To better estimate the seismic hazard associated with these two faults, we jointly invert interferometric synthetic aperture radar (InSAR) and GPS data to image the spatial distribution of interseismic coupling along the eastern part of both the NAF and EAF. We perform the inversion in a Bayesian framework, enabling to estimate uncertainties on both long‐term relative plate motion and coupling. We find that coupling is high and deep (0–20 km) on the NAF and heterogeneous and superficial (0–5 km) on the EAF. Our model predicts that the Elazığ earthquake released between 200 and 250 years of accumulated moment, suggesting a bicentennial recurrence time.