Douglas Straub

Douglas Straub

Auto-generated profile, based on publicly available information

Douglas Straub

NETL

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2006
Verified
Conference Paper
Closed access
PDF file
RERyan G. Edmonds
Ryan G. Edmonds
RSRobert C J Steele
Robert C J Steele
JWJoseph Williams
Joseph Williams
DSDouglas L. Straub
Douglas L. Straub
KCKent H. Casleton
Kent H. Casleton
ABAvtar Bining
Avtar Bining
An ultra lean-premixed Advanced Vortex Combustor (AVC) has been developed and tested. The natural gas fueled AVC was tested at the U.S. Department of Energy’s National Energy Technology Laboratory (USDOE NETL) test facility in Morgantown (WV). All testing was performed at elevated pressures and inlet temperatures and at lean fuel-air ratios representative of industrial gas turbines. The improved AVC design exhibited simultaneous NOx/CO/UHC emissions of 4/4/0 ppmv (all emissions are at 15% O2 dry). The design also achieved less than 3 ppmv NOx with combustion efficiencies in excess of 99.5%. The design demonstrated tremendous acoustic dynamic stability over a wide range of operating conditions which potentially makes this approach significantly more attractive than other lean premixed combustion approaches. In addition, a pressure drop of 1.75% was measured which is significantly lower than conventional gas turbine combustors. Potentially, this lower pressure drop characteristic of the AVC concept translates into overall gas turbine cycle efficiency improvements of up to one full percentage point. The relatively high velocities and low pressure drops achievable with this technology make the AVC approach an attractive alternative for syngas fuel applications.

6 January 2024 in Applied Thermal Engineering
Verified
Journal Article
Closed access
MSMatthew Searle
Matthew Searle
SRSridharan Ramesh
Sridharan Ramesh
DSDouglas Straub
Douglas Straub

7 September 2021
Verified
Report
Open access
PDF file
MSMatthew Searle
Matthew Searle
ARArnab Roy
Arnab Roy
SRSridharan Ramesh
Sridharan Ramesh
DSDouglas Straub
Douglas Straub
An experimental study was performed to consider the impact of surface roughness on heat transfer and pressure drop to supercritical carbon dioxide (sCO2) in additively manufactured channels. All tests were performed in the Heat Exchange and Experimental Testing (HEET) rig at the U.S. Department of Energy’s (DOE) National Energy Technology Laboratory (NETL) in Morgantown, West Virginia. Four test articles were considered. The first was a hydrodynamically smooth, drawn tube. The other three were additively manufactured channels with square and rectangular cross sections, which were characterized by sand-grain roughness to hydraulic diameter ratios spanning 0.0029 to 0.0073. Friction factors were determined by measuring the tube mass flow rate and pressure drop. The tube side heat transfer coefficient was measured using the Wilson plot technique. It was found that the friction factor results were 8% less than the Colebrook correlation. Greater deviation was observed between the heat transfer results and the correlations. The Gnielinski correlation overpredicted the experimental points by nominally 30% and the Norris correlation overpredicting the experimental points by nominally 25%. A thermal performance factor was formed from the friction factor augmentation and Nusselt numbr augmentation results. These results indicated a 10% improvement in heat duty for a heat exchangermore » constructed utilizing a tube with relative to a heat exchanger utilizing a smooth, conventional tube. « less

30 January 2025
Verified
Report
Closed access
DSDouglas Straub
Douglas Straub
ATAndrew Tulgestke
Andrew Tulgestke
MSMatthew Searle
Matthew Searle
EREdward Robey
Edward Robey

24 September 2024
Verified
Conference Paper
Open access
PDF file
MSMatthew Searle
Matthew Searle
OGOwen Grabowski
Owen Grabowski
EREdward Robey
Edward Robey
TFTim Floyd
Tim Floyd
MKMatthew Krull
Matthew Krull
DSDouglas Straub
Douglas Straub
This presentation provides an update to the University Turbine Systems Research meeting on research performed at NETL in areas of sCO2 heat transfer for direct cycle power generation and aerothermal research to improve the efficiency and reduce emissions of small gas turbines. Specific topics include a novel test approach to measure the performance of a thermal barrier coating in-situ and fabrication of advanced, additively manufactured airfoils for testing in a high speed cascade.

20 May 2025
Verified
Conference Paper
Closed access
RRRachel Ross
Rachel Ross
MKMatthew Krull
Matthew Krull
SLStephen Lynch
Stephen Lynch
MSMatthew Searle
Matthew Searle
FAForrest Ames
Forrest Ames
DSDouglas Straub
Douglas Straub