We measure and discuss the complex refractive index of conventional ethylene vinyl acetate (EVA) and an EVA with enhanced UV-transmission based on spectroscopic ellipsometry, transmission and reflection measurements over the wavelength range from 300-1200 nm. Ray tracing of entire solar cell modules using this optical data predicts a 1.3% increase in short circuit current density (Jsc) at standard test conditions for EVA with enhanced UV transmission. This is in good agreement with laboratory experiments of test modules that result in a 1.4% increase in Jsc by using a UV transparent instead of a conventional EVA. Further, ray tracing simulations with realistic irradiation conditions with respect to angular and spectral distribution reveal an even larger Jsc increase of 1.9% in the yearly average. This increase is largest in the summer months with an increase of up to 2.3%
This paper reviews the main research results related to PERC+ silicon solar cells. Compared to today’s industry typical passivated emitter and rear cell (PERC) silicon solar cells with full-area rear aluminum layer, PERC+ solar cells apply an aluminum finger grid on the rear side and hence are able to absorb diffuse light from the rear side in addition to the direct sunlight which is absorbed from the front side. This bifaciality increases the energy yield of silicon solar modules by up to 25%. Since its first publication in 2015, the PERC+ cell concept has been rapidly adopted by several solar cell manufacturers due to the very similar process technology of bifacial PERC+ cells and main stream monofacial PERC cells. We summarize technological challenges, published PERC+ conversion efficiencies and PERC+ module technologies. First energy yield data of PERC+ field installations demonstrate the high energy yield potential of PERC+ solar cells.
5 November 2019 in Progress in Photovoltaics: Research and Applications
We present a systematic study on the benefit of the implementation of poly‐Si on oxide (POLO) or related junctions into p‐type industrial Si solar cells as compared with the benchmark of Passivated Emitter and Rear Cell (PERC). We assess three aspects: (a) the simulated efficiency potential of representative structures with POLO junctions for none (=PERC+), one, and for two polarities; (b) possible lean process flows for their fabrication; and (c) experimental results on major building blocks. Synergistic efficiency gain analysis reveals that the exclusive suppression of the contact recombination for one polarity by POLO only yields moderate efficiency improvements between 0.23%abs and 0.41%abs as compared with PERC+ because of the remaining recombination paths. This problem is solved in a structure that includes POLO junctions for both polarities (POLO2), for whose realization we propose a lean process flow, and for which we experimentally demonstrate the most important building blocks. However, two experimental challenges—alignment tolerances and screen‐print metallization of p+ poly‐Si—are unsolved so far and reduced the efficiency of the “real” POLO2 cell as compared with an idealized scenario. As an intermediate step, we therefore work on a POLO IBC cell with POLO junctions for one polarity. It avoids the abovementioned challenges of the POLO2 structure, can be realized within a lean process flow, and has an efficiency benefit of 1.59%abs as compared with PERC—because not only contact recombination is suppressed but also the entire phosphorus emitter is replaced by an n+ POLO junction.
III-V/Si tandem solar cells have demonstrated efficiencies exceeding the theoretical efficiency limit of silicon solar cells. On the cell level, device modeling shows that three-terminal tandem (3T) devices with rear contacted bottom Si cells perform as well as operating the subcells independently (4T). However, integrating these 3T devices in a module requires voltage matching of the top and the bottom cell. Here, we investigate the robustness of parallel/series-interconnected 3T III-V/Si tandem devices in comparison with series-interconnected two terminal (2T) and independently operated (4T) devices with respect to spectral, thermal, and resistive effects. Under most conditions, interconnected 3T devices are able to perform as well as those with independent operation of the top and bottom cell, and 3T devices significantly outperform 2T devices.