4 December 2024 in IEEE Transactions on Nuclear Science
This review focuses on silica-based optical fibers, guiding light through the total internal reflection mechanism, that are currently used in telecommunications and sensor networks. Section I briefly introduces the fiber and fiber sensor technologies. Section II presents their various applications in radiation environments. In section III, the radiation effects on optical fibers are explained, first at a microscopic scale, with the description of point defects generated by irradiation. Then, the macroscopic consequences of the appearance of these point defects are discussed, in particular the phenomena of radiation-induced attenuation (RIA), radiation-induced emission (RIE) and radiation-induced refractive index change (RIRIC). RIA impacts nearly all applications under irradiation. We then detail the various parameters, intrinsic or extrinsic to the optical fibers that influence their amplitudes and kinetics. This improved knowledge paved the way for the radiation hardening of optical fibers through various approaches, either at material, component or system levels, that are described in section IV. Recent advances are presented for passive and for active rare-earth doped optical fibers and systems. Then, the use of fiber optic sensors is introduced, starting in section V with the latest advances in radiation-hardened point or distributed sensors. Then, the potential of this technology for radiation detection, beam instrumentation and dosimetry applications is assessed in section VI. Finally, the future prospects and the main challenges to be met in order to accelerate the implementation of this technology in the harshest environments are discussed.
20 January 2021 in IEEE Transactions on Nuclear Science
Point or distributed optical fiber (OF)-based dosimeters can exploit the observed linear dependence of the radiation-induced attenuation (RIA) at 1550 nm in phosphosilicate OFs to monitor the total ionizing dose (TID). The temperature dependence of the radiation sensitivity coefficients at 1550 nm (expressed in dB km -1 Gy -1 ) of three phosphorus-doped single-mode OFs has been investigated between -80 °C and 300 °C for TID ranging from 1 Gy to 1 kGy(SiO 2 ). Our measurements reveal the same temperature dependence of the calibration factor for the three fibers at the higher temperatures (>120 °C) where the P1 defects, at the origin of the IR-RIA, are metastable. However, the uncertainties on the TID measurements through the fiber-based dosimeter remain within the 15% for temperatures ranging from -80 °C to 120 °C for the three tested fibers. The independence of the RIA and then of the dose measurements from the dose rate is also maintained in this temperature range.
6 December 2021 in IEEE Transactions on Nuclear Science
Ge-doped optical fibers are considered as radiationtolerant waveguide. Even if their transmission in the infrared (IR) domain is degraded under irradiation, for most of the applications, their radiation induced attenuation (RIA) remains acceptable. Space harsh environment is characterized by low dose and doserate constraints meaning that germanosilicate fibers are often employed for data links. However, the temperature can largely vary in space and is known to impact the RIA levels and kinetics. We studied here systematically the combined temperature and radiation effects induced on the transmission, at the telecom wavelengths, of a Ge-doped fiber, between -80°C and 80°C up to a total ionizing dose (TID) of 10 kGy(SiO2) – 1 Mrad. Our measurements highlight larger RIA levels at low temperatures than at room temperature (RT). At our highest TID, it increases by a factor of ~40 and ~20, respectively at 1310 nm and 1550 nm, when the irradiation is performed at -80°C instead of RT. A model is reported to study the activation energy of the radiation-induced point defects responsible of the IR-RIA. This simple model could help in predicting the fiber vulnerability for various mission profiles.
20 March 2020 in IEEE Transactions on Nuclear Science
We analyzed the simultaneous response to radiation and temperature exposure of radiation-sensitive optical fibers doped with Aluminum, Phosphorus and/or Germanium in the framework of the CERTYF (Combined Effects of Radiations, Temperature and hYdrogen on silica-based optical Fibers) project, whose aim is to build a predictive model based on intrinsic and extrinsic optical parameters.