4 February 2025 in Physical Review Applied
We present an approach allowing an optically pumped magnetometer (OPM) to be operated within the Earth’s magnetic field as a vector magnetometer, the sensitive axis of which can be freely defined. This approach enables the measurement of any vector component of the Earth’s magnetic field with the same sensitivity. The OPM is realized by a microfabricated cesium-vapor cell with nitrogen buffer gas, which is immersed in a constant homogeneous bias field of approximately 730 μ T . Since this bias field is about one order of magnitude stronger than the Earth’s magnetic field, it defines the sensitive axis of the OPM. The bias field is generated by solid-state magnets and has been designed to exhibit a very low relative inhomogeneity ( < ± 10 − 4 in relative units) within the vapor-cell dimensions as well as a point of vanishing temperature dependence at around 40 ∘ C . The OPM utilizes the light-narrowing effect, which enables effective suppression of spin-exchange relaxation even in such a large magnetic field amplitude. Based on this implementation, we demonstrate a white-noise floor of below 60 fT / Hz in the frequency interval between 100 Hz and 600 Hz and a 3-dB sensor bandwidth of > 5 kHz . Our approach enables unshielded ultrasensitive vectorial measurement capabilities that are relevant in many important applications.
5 December 2011 in Superconductor Science and Technology
13 December 2018 in Superconductor Science and Technology
We report on a novel concept and prototype development of a coreless SQUID-based charged-particle beam monitor as a non-destructive diagnostic tool for accelerator facilities. Omitting the typically used pickup coil with a high magnetic permeability core leads to a significant improvement in low-frequency noise performance. Moreover, a revised shielding geometry allows for very compact and rather lightweight device designs. Based on highly sensitive SQUIDs featuring sub-micron cross-type Josephson tunnel junctions, our prototype device exhibits a current sensitivity of about 6 pA Hz −1/2 in the white noise region. Together with a measured shielding factor of about 135 dB this opens up the way for its widespread use in modern accelerator facilities.
19 January 2018 in Superconductor Science and Technology
The effect of flux trapping on the flux-voltage characteristics of multi-loop SQUID magnetometers was investigated by means of repeated cool-down cycles in a stepwise increased magnetic background field. For a SQUID with N parallel loops, N different flux offsets, each separated by were observed even in zero magnetic field. These flux offsets further split into a so called fine structure, which can be explained by minor asymmetries in the SQUID design. The observed results are discussed with particular regard to their impact on the previously presented absolute SQUID cascade vector magnetometer.