11 July 2019 in IEEE Journal of Solid-State Circuits
This paper presents the design and measured continuous-wave (CW) performance of a three-stage $K$ -band monolithic microwave integrated circuit (MMIC) power amplifier (PA) implemented in a 150-nm GaN-on-SiC process. The transistor peripheries are staged at a ratio of 1:2:8, and the output stage consists of two reactively combined $8 \times 100~\mu \text{m}$ HEMTs with individual source vias. The measured peak output power is greater than 4 W with peak power added efficiency (PAE) of greater than 40%. The output power exceeds 3.2 W over the frequency range of 18–24 GHz with less than 1.5-dB variation. The three-stage architecture enables greater than 20 dB of saturated gain from 18.5 to 24 GHz. The bandwidth, output power, and efficiency performance are investigated as a function of output stage drain voltage. A statistical analysis for 230 die fabricated on five wafers is presented, and eight MMICs are mounted and characterized over power and frequency.
24 April 2019 in IEEE Transactions on Microwave Theory and Techniques
This paper investigates the linearization of high-efficiency multistage PAs through gate bias modulation derived from the envelope of the RF input signal. We show that separate control of the driver- and power-stage gate bias voltages allows for independent linearization of gain and phase. An iterative algorithm determines signal-dependent gate voltage functions that minimize amplitude-to-amplitude (AM/AM) and amplitude-to-phase (AM/PM) distortion, and is demonstrated on a 10-W high-efficiency X-band GaN monolithic microwave integrated circuit (MMIC) PA with a custom-designed hybrid dual-gate bias modulator. The noise power ratio (NPR) of a 5-MHz-wide signal is improved by as much as 9.4 dB compared to the PA with a static bias, without degradation in power-added efficiency (PAE) and gain. The measured average PAE improves from 19.9 % at 9.8-dB backoff by 0.8 points, with a saturated gain increase of 0.2 dB at 9.7 GHz. A long-term evolution (LTE) signal with different envelope statistics and a 10.6-dB peak-to-average power ratio (PAPR) is amplified with an adjacent channel power ratio (ACPR) improvement of up to 7.9 dB.
16 November 2018 in IEEE Transactions on Microwave Theory and Techniques
The goal of the work presented in this paper is to demonstrate an efficient method of amplifying multiple concurrent signals over a large bandwidth using a supply modulation approach. A single-stage octave bandwidth (2-4 GHz) power amplifier (PA) with greater than 10-W output power and drain efficiency ranging from 48%-60% is presented. The amplifier is tested with several reduced-bandwidth supply modulation trajectories that are constructed as an even-termed power series of a 10-MHz LTE signal envelope. A greater than 30% point increase in eta D is achieved while maintaining less than -45-dB ACPR with digital predistortion (DPD). Two 10-MHz LTE signals with 800-MHz spacing are then amplified using a similar bandwidth-reduction technique. A greater than 20% point increase in eta D is seen with an improvement in linearity through the use of multidimensional DPD. The method presented here can be extended to more than two concurrent signals of arbitrary spacing for a PA with large RF bandwidth.