Fabrication of highly efficient solar cells is critical for photovoltaic applications. A bandgap-graded absorber layer can not only drive efficient carrier collection but also improve the light harvesting. However, it is very difficult to realize such a bandgap-graded structure in kesterite-structured films due to the similar cation diffusion rates in the high-temperature selenization process. Here, we design and successfully realize a bandgap grade in Cu2ZnSn(S,Se)4 (CZTSSe) film by sufficient annealing during the deposition of an Al-doped ZnO film. This annealing strategy facilitates the solid-state ion-exchange reaction between Cu+ and Cd2+ at the heterojunction interface. Consequently, n-type CdS is partially converted to p-type Cu2S and CZTSSe is converted to Cd-graded CZTSSe, thereby forming a desired bandgap-graded CZTSSe solar cell. The tailored band alignment between the p–n junction not only improves the electron transport but also reduces the carriers recombination. As a consequence, the open-circuit voltage and fill factor are significantly improved, and a certified power conversion efficiency of 12.25% is obtained. The graded bandgap engineering of the absorber achieved here illuminates the future pathway towards highly efficient solar cells.
21 September 2020 in Journal of Materials Chemistry A
A Li+-doping strategy is a promising route for achieving highly efficient Cu2ZnSn(S,Se)4 (CZTSSe) photovoltaic devices with a large grain absorber layer, high p-type carrier concentration and good band alignment at the Cu2ZnSn(S,Se)4/CdS interface. However, Li+-doped CZTSSe solar cells based on in situ and pre-deposition doping strategies reported thus far generally suffer from massive lithium losses and sodium rejection due to the soda-lime glass substrate. Therefore, simultaneously fulfilling the goals of simple and efficient Li+-doping remains a major technical challenge, which may be addressed, as we demonstrate here, with the development of a Se&LiF co-selenization process. By engineering the band alignment of the Cu2ZnSn(S,Se)4/CdS interface through the Se&LiF co-selenization process, an encouraging efficiency of 11.63% with an open-circuit voltage deficit of 0.583 V has been reached. Furthermore, the crystallinity of the absorber layer and the distribution of copper are improved, and a more copper-poor CZTSSe surface is formed. This novel Li+-doping strategy introduces a new approach towards the goal of high-performance CZTSSe solar cells compatible with a simple manufacturing process and excellent performance.
6 March 2025 in ACS Applied Materials & Interfaces
Kesterite Cu2ZnSn(S,Se)4 (CZTSSe) has emerged as a promising photovoltaic material due to its low cost and high stability. The CZTSSe film for high-performance solar cells can be obtained by annealing the deposited CZTS precursor films with selenium (a process known as selenization). The design of the selenization process significantly affects the quality of the absorber layer. In this work, we systematically investigate the impact of heating rate on the selenization kinetics and the microstructural characteristics of the films using a two-step selenization method. The results indicate that a slow heating rate promotes surface crystallization, resulting in a thick and dense layer of large grains at the film surface that impedes the diffusion of Se vapor. Conversely, a rapid heating rate enhances the diffusion of Se into the interior of the film, synthesizing more low-melting-point intermediate compounds that facilitate grain growth and reduce the thickness of fine grains at the film bottom. Ultimately, a CZTSSe solar cell with an efficiency of 10.17% was fabricated at a heating rate of 200 °C/min. This research deepens the understanding of thin film growth mechanisms and advances the development of high-performance solar cells.