7 May 2008 in New Journal of Chemistry
ADArnold Desmartin-Chomel
MOFs permit the paraalkylation of large polyaromatic compounds with nearly 100% of regioselectivity, offering new alternatives to standard zeolite catalysts.
16 December 2013 in Journal of Materials Chemistry A
Innovative asymmetric oxygen-transport membrane architectures were prepared by combining freeze-casting and film deposition techniques. Freeze-casting enabled the optimization of the gas transport through the support by creating a hierarchical porosity while a dense top-layer of 30 μm was coated over this support by screen printing. The versatility of this technique was demonstrated by preparing highly porous bodies made of fast ionic conductors, e.g. perovskites and doped ceria fluorites, with a large number of applications in catalysis, electrochemistry and gas separation. Permeation tests using an all-La0.6Sr0.4Co0.2Fe0.8O3−δ asymmetric membrane proved the beneficial effect of such porous supports over the O2 fluxes with a maximum value of 6.8 mL min−1 cm−2 at 1000 °C, markedly above the results achieved so far with conventional preparation techniques. Gas permeance study through the porous freeze-cast support showed that the particular pore structure allows the gaseous transport resistance to be minimized. The related pressure drop is found to be very low in comparison with conventional porous supports, e.g. tape-cast supports, with for example only 0.59 bar mm−1 with argon at 800 °C for an inlet flow of 400 mL min−1 cm−2. Finally, the stability of the asymmetric membrane has been evaluated under CO2 atmosphere during 48 hours and at 900 °C. The membrane is found to be stable without deactivation nor decrease in the O2 permeation flux.
1 February 2014 in International Journal of Hydrogen Energy
28 July 2014 in ChemSusChem
2 June 2010 in Fuel Cells
The mixed ionic–electronic conductivity under dilute hydrogen, the stability and the catalytic activity under propane:air type mixtures of a series of LAMOX oxide‐ion conductors have been studied. The effect of exposure to dilute hydrogen on the conductivity of the β‐La2(Mo2 – yWy)O9 series at 600 °C depends on tungsten content: almost negligible for the highest (y = 1.4), it is important for La2Mo2O9 (y = 0). In propane:air, all tested LAMOX electrolytes are stable at 600–700 °C, but get reduced when water vapour is present. La2Mo2O9 is the best oxidation catalyst of the series, with an activity comparable to that of nickel.The catalytic activity of other tested LAMOX compounds is much lower, (La1.9Y0.1)Mo2O9 showing a deactivation phenomenon. These results suggest that depending on composition, La2(Mo2 – yWy)O9 compounds could be either electrolytes in single‐chamber SOFC and dual‐chamber micro‐SOFC (y = 1.4) or anode materials in dual‐chamber SOFC (low y) or oxidation catalysts in SOFCs operating with propane (y = 0).