In recent years, printed and flexible gas sensors have quickly emerged as an innovative area of great interest because of their lightness and low cost. These flexible sensors can be easily integrated into autonomous systems for many applications such as smart food packaging and premature disease detection. In this paper, a novel approach was applied to manufacture a fully inkjet-printed gas sensor on a flexible polymeric foil. A platinum heater and gold electrodes were printed on the top side of the substrate, separated by a thin insulating layer of printed polyimide. An aqueous sol–gel process was adopted to synthesize nanosized SnO2-based sol that guarantees crystallization at 350 °C, which is entirely consistent with the polyimide foil. Then, the sol was transformed into a stable ink and inkjet printed over the gold electrodes. The printability of different inks was optimized to ensure flawless ejection of droplets, and the complex physico-chemical interactions between the inks and different interfaces were controlled to get well-defined patterns with high resolution. Finally, electrical measurements of the printed sensor were performed to characterize the response and sensitivity to different concentrations of ethanol, ammonia and carbon monoxide gases, at a working temperature of 300 °C, in dry and wet air.
The mixed ionic–electronic conductivity under dilute hydrogen, the stability and the catalytic activity under propane:air type mixtures of a series of LAMOX oxide‐ion conductors have been studied. The effect of exposure to dilute hydrogen on the conductivity of the β‐La2(Mo2 – yWy)O9 series at 600 °C depends on tungsten content: almost negligible for the highest (y = 1.4), it is important for La2Mo2O9 (y = 0). In propane:air, all tested LAMOX electrolytes are stable at 600–700 °C, but get reduced when water vapour is present. La2Mo2O9 is the best oxidation catalyst of the series, with an activity comparable to that of nickel.The catalytic activity of other tested LAMOX compounds is much lower, (La1.9Y0.1)Mo2O9 showing a deactivation phenomenon. These results suggest that depending on composition, La2(Mo2 – yWy)O9 compounds could be either electrolytes in single‐chamber SOFC and dual‐chamber micro‐SOFC (y = 1.4) or anode materials in dual‐chamber SOFC (low y) or oxidation catalysts in SOFCs operating with propane (y = 0).