The fabrication of perovskite solar cells in ambient air is of significant economic benefit. However, to date, there is no satisfactory solution to achieve this, and the reported results of solar cells fabricated in ambient air vary significantly. It has been observed through studies of the “turbid point”, a time point at which the appearance of the precursor film changes from transparent to turbid, that the crystallization of methylammonium lead iodide (MAPbI3) precursor films is strongly affected by humidity. A theoretical model based on the dependence of crystallization on evaporation was developed. We further designed a “humidity-insensitive antisolvent method” based on the turbid point and its tuning to control the fabrication of high-quality MAPbI3 films and solar cells irrespective of the ambient humidity levels. Note that a champion device prepared in ambient air at 90% RH exhibits the efficiency of 19.5%, which is highest among those of the devices prepared in ambient air with over 30% RH. Our study may also impact other perovskite devices and inspire other researchers to perform innovative experiments.
Inorganic tin–lead perovskites with low bandgap (1.2–1.4 eV) are desired absorber materials for solar cells owing to their ideal bandgap and compositional stability. However, such tin–lead perovskites are currently subject to inferior power conversion efficiency (PCE) and the origin remains unclear. Here, for the first time, we report the metal-cation-derived unsynchronized crystallization behavior of inorganic tin–lead perovskite, exemplifying by a representative composition CsPb0.7Sn0.3I3. A tin-perovskite-targeted crystallization modulation agent, 1-(4-fluorophenyl) piperazine (1-4FP), is introduced to synchronize the B-site alloying through its strong targeted bonding with SnI2, resulting in substantially enhanced film quality with better morphology and photoelectrical properties. Furthermore, first-principles molecular dynamics simulations reveal that the agent regulates the crystallization route toward the pure phase of CsPb0.7Sn0.3I3 by suppressing the preforming of tin perovskite. With our proposed approach, the best device attains PCE of 17.55%, which is record-high for inorganic tin–lead perovskite solar cells. In addition, treated devices show excellent stability with only 10% and negligible loss after being exposed to 1 sun intensity for 700 h and being stored in N2 after over 4000 h, respectively. Our findings open a new avenue of crystallization route design in inorganic tin–lead perovskites, so as to obtaining high-quality perovskite films and associated solar cells.
The stability issue of perovskite solar cells is the greatest bottleneck on the way to commercialization. Here, we report the degradation mechanism of perovskite solar cells (PSCs) with inverted structure of fluorine-doped tin oxide (FTO)/Cu:NiO x /MAPbI 3 /PC 61 BM/Ag. The oxidative degradation of PC 61 BM electron transport layer forms pinholes and leads to the water-catalyzed decomposition of perovskites. The formation of silver iodide confirms the iodine is from decomposition of perovskites. The instability of inverted PSCs based on Cu:NiO x is owing to corrosive behavior of silver electrode. In addition, we find that a small amount of bromine doping in the perovskite material can delay the corrosion of the silver electrode. This paper demonstrates it is essential to deeply understand the degradation mechanism of the devices and a small amount of bromine doping is a feasible strategy to suppress the corrosion of the silver electrodes.
13 April 2021 in ACS Applied Materials & Interfaces