Huliang Ma

Huliang Ma

Auto-generated profile, based on publicly available information

Huliang Ma

School of Mechanical and Vehicle Engineering, Taiyuan University of Technology, Taiyuan, China

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 July 2021 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
HMHuliang Ma
Huliang Ma
YWYanqing Wang
Yanqing Wang
MLMing Lv
Ming Lv
SYShengqiang Yang
Shengqiang Yang

16 May 2022 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
HMHuliang Ma
Huliang Ma
YWYanqing Wang
Yanqing Wang
MLMing Lv
Ming Lv
SYShengqiang Yang
Shengqiang Yang

30 June 2021 in Research Square
Verified
Preprint
Open access
PDF file
HMHuliang Ma
Huliang Ma
YWYanqing Wang
Yanqing Wang
MLMing Lv
Ming Lv
SYShengqiang Yang
Shengqiang Yang
The application of wire EDM to the machining of cylindrical parts is an emerging research topic. The current research is mainly focused on the machining of micro-cylindrical parts, and there is little research on the general-sized parts. This paper proposes to apply the principle of contour approximation method to the machining of cylindrical parts of general size. First, the basic principle of the contour approximation method is introduced, and the machining process is divided into three parts: roughing, semi-finishing and finishing. Roughing corresponds to polygon cutting. Second, the various indicators of polygon cutting are analyzed. The influence of the number of polygonal sides on the residual height and residual area is analyzed. Two methods are proposed for polygon cutting: sequential cutting and multiple edge cutting. The calculation formulas for the processing volume of the two methods are deduced. By comparing the two methods, it is found that different methods are applicable to different part sizes. At last, machining experiments were carried out. The selection of residual variables and the determination of polygon machining methods are detailed. The process parameters and machining time of each stage are listed. In addition, the measurement results of each stage of the machining are also analyzed.

16 March 2021 in Research Square
Verified
Preprint
Open access
PDF file
HMHuliang Ma
Huliang Ma
YWYanqing Wang
Yanqing Wang
MLMing Lv
Ming Lv
SYShengqiang Yang
Shengqiang Yang
Increasing the machining efficiency of middle speed wire electrical discharge machining (MS-WEDM) is usually through optimizing process parameters, but the discharge servo parameters of the servo controller can also be optimized to achieve the same purpose. This paper develops a multi-mode servo controller for MS-WEDM to investigate discharge servo parameters. Firstly, the structure and control principle of the servo controller are introduced, and the core functions are described in detail. Secondly, it introduces the discharge servo parameters that can be optimized: gap state threshold and feedback period. At the same time, the platform specifications and parameters for optimization experiments are introduced. Thirdly, the experimental scheme and result analysis of parameter optimization are described, and the optimized parameters are obtained. Finally, different machining experiments are carried out for the multi-mode of the servo controller to investigate the effectiveness and practicability of the different machining servo modes. In the parameter optimization and machining experiments, the recording function of the servo controller was used to draw the speed curve, and the servo response effects of different servo modes was obtained.