1 October 2017 in Journal of Materials in Civil Engineering
This paper presents the results of experimental investigations on sand–rubber tire shred mixtures. The sand and rubber tire shreds considered were of uniform fine size ( ). Static and dynamic characterization was carried out for pure sand, pure rubber, and sand–rubber tire shred mixtures with rubber content varying 10, 30, and 50% by weight. First, strain-controlled consolidated undrained triaxial tests were carried out to determine static shear strength. Strain-controlled cyclic triaxial tests were then conducted to evaluate shear moduli and damping ratios in the medium to large strain range. Undrained moduli obtained from both experiments were compared. It was found that the mixture with 10% rubber content had the satisfactory static and dynamic properties required for seismic isolation of low-rise buildings.
1 May 2014 in Géotechnique
This paper examines seismic effects on fixed-head, end-bearing piles installed through soft clay, using centrifuge and numerical modelling. The numerical analyses were conducted using a non-linear hysteretic, stiffness-degrading model for the clay and were validated using centrifuge data. Numerical analyses were used to extend the range of soil, pile and ground motion parameters which could not be studied in the centrifuge. Based on the centrifuge and numerical results, a framework for estimating earthquake-induced bending moments in fixed-head piles was established, which takes into account superstructural mass, ground motion and, in an approximate way, non-linear stress–strain behaviour. In this framework, pile response is sub-divided into two kinds, namely, ‘stiff' and ‘flexible', based on the notion of an active length over which significant bending moment is developed. A relationship for the active length is developed based on regression of the centrifuge and numerical data. If the pile length is shorter than its active length, it is considered to be stiff and significant bending is expected to develop over its entire length. The regressed bending moment relationship for stiff piles shows that the stiffness of the pile–soil system is dominated by that of the pile, and non-linearity in the stress–strain behaviour of soil does not feature strongly. Piles whose lengths are longer than their active lengths are termed ‘flexible' piles. The regressed bending moment relationship for flexible piles shows that the supporting effect of the soil is more significant, and the non-linearity in the stress–strain behaviour of the soil correspondingly becomes more important. For all piles, the study shows that the pile head and soil masses have significant influence on the bending moment.
13 May 2011 in Journal of the American Chemical Society
19 January 2019 in Geotechnical and Geological Engineering
29 December 2017 in International Journal of Geotechnical Engineering
The paper presents a numerical investigation carried out for helical pile installed in loose cohesionless soil with varying density and dimensions of the helical blade/shaft. The analyses are carried out using three-dimensional finite-element software, Plaxis 3D AE. The load–deformation behaviour under axial compression and tension is compared with the results from a case study of field investigation and numerical analysis reported. The model thus calibrated is then used for a parametric study and the results were used to arrive at a set of generic equations to estimate the axial capacities. The investigation shows that relative density of sand plays an important role in the response of ultimate axial capacities towards various geometrical variations. Presence of helical blade and its embedment ratio (H/D h ) were found to influence axial capacity significantly. However, the shaft diameter is found to play a relatively less important role compared to increase in helical blade diameter while considering ultimate axial load capacities.
1 October 2014 in Soil Dynamics and Earthquake Engineering