This article presents a new uncompensated analog pulsewidth modulation (PWM) pixel circuit employing pull-up control for micro-light-emitting diode (LED) display. The time of emitting light for the micro-LED working at the constant current is modulated by the analog data voltage. A compensated pixel circuit is also further developed to improve the display uniformity by compensating the threshold voltage shift of PWM thin-film transistor (TFT) and driving TFT. Based on the back-channel etch (BCE) metal oxide TFTs process, $16\times $ GGG $\times29$ LED array with the uncompensated pixel circuit and 16 $\times {G}\,\,\times15$ LED array with the compensated pixel circuit are simultaneously fabricated on the same glass substrate. Compared with the uncompensated pixel circuit array, the display uniformity of the compensated pixel circuit array is improved from 74% to 88%.
This paper proposes an organic photodiode (OPD) image sensor based on indium zinc oxide (IZO) thin-film transistors (TFTs). The sensor array has a 256 × 256 pixel format with a 50 μm pixel size. The continuous OPD fabricated by the solution process is stacked vertically on the top of the IZO TFT backplane. A measurement system is built based on the readout IC driven by the field programmable gate array (FPGA). It is shown that the optical image can be successfully detected by the sensor array with good clarity and high quality. With a leakage current of the IZO TFT as low as 5×10 -14 A and a dark current of OPD as low as 10 -13 A, the total electronic noise is less than 683 e - .
13 November 2019 in Journal of Information Display
This paper presents a new gate driver integrated by In-Zn-O thin-film transistors (IZO TFTs) with the etch stop layer (ESL) structure, in which only a single negative power source is used on account of a new boosting module. The boosting module is controlled only by the VIN signal for generating a lower level than VSS. The proposed gate driver with 15 stages is fabricated through the IZO TFT process on a glass substrate to verify its function. The experiment results showed that the proposed gate driver can successfully output full-swing waveforms with resistive load RL=2 kΩ and capacitive load CL=30 pF at the 16.7 and 66.7 kHz clock frequencies, and can also output as small as 3.2 μs pulse width with little distortion, revealing good stability.