Way for applying tantalum coating with a given structure to the surface of an alloy with a shape memory effect NiTi to increase the biocompatibility of implants from this alloy is presented. The coating was synthesized by direct current (DC) magnetron sputtering. The changes sequence of the structural-phase states depending on the thickness of the coating, that is, the rate of its deposition, has been established. It is shown that at a low magnetron power, ∼14 W in present study, a single-phase α -Ta coating with a bcc structure and a high degree of perfection of the crystal lattice is successfully synthesized on the titanium nickelide surface.
15 February 2025 in Metallurgical and Materials Transactions A
This paper presents a detailed study of the fracture surfaces of 12Kh18N10T austenitic stainless-steel specimens subjected to short-term mechanical testing at various temperatures: 24°C, 350°C, and 450°C. The specimens for the study were fabricated from spent nuclear fuel of the BN-350 reactor. The research was conducted within the framework of a multi-level approach to physical mesomechanics, which allowed for a deeper understanding of the complex processes occurring in the material under different temperature regimes. In particular, a thorough analysis of the changes in the steel's plasticity with increasing test temperature was carried out, revealing a significant dependence of this parameter on the conditions of deformation localization. It was shown that the reduction in plasticity with increasing test temperature is associated with a quasi-uniform distribution of stresses in the zones of deformation localization. These zones of local stress concentration were caused by processes that led to an increase in the material's porosity, which, in turn, was due to accommodation processes of the rotational type. Thus, the study demonstrated the importance of considering local changes in the material's structure, which can significantly affect its mechanical properties under varying operating conditions. The obtained results may contribute to a deeper understanding of the processes occurring in austenitic steels used in extreme conditions and aid in the development of more reliable materials for use in nuclear and other high-stress systems.
The paper studies the formation and development of gas porosity in EK-181 steel upon irradiation with 84Kr15+ ions and subsequent long-term annealing. Irradiation and annealing were carried out at a temperature of 350°C. When steel is irradiated, gas porosity is formed in a layer up to 100 nm deep from the surface. The sizes of gas-filled pores do not exceed 23 nm2. Annealing following irradiation leads to the association of small krypton bubbles into clusters and enlargement up to 150 nm2. In this case, “blisters” with a high content of krypton are formed on the surface.