14 October 2019 in Journal of Lightwave Technology
We describe a series of optical transmission experiments based around single-mode multi-core fiber (MCF) amplified with 19-core, C + L band Erbium-doped fiber amplifier (EDFA). The cladding-pumped amplifier uses two fan-cooled multi-mode pumps in each of C and L band to provide gain bandwidth over more than 75 nm. For recirculating transmission of PDM-16QAM signals on 345 wavelength carriers between 1530.52 nm and 1605.52 nm, we measure 0.715 Pb/s transmission over a distance of 2009 km (64 recirculations), equivalent to a throughput-distance product of 1.44 exabit/s x km. Next, using PDM-QPSK modulation, we investigate trans-oceanic transmission distances, measuring throughputs of 18.6 Tb/s and 14.5 Tb/s in 2 cores after 255 recirculations, a distance of 8007 km. Further, we evaluate the combined EDFA and fiber crosstalk penalties showing a core and wavelength dependence in agreement with previous MCF crosstalk measurements. These results demonstrate the potential of high core-count EDFAs to combine both high capacity transmission over transoceanic distances with benefits of SDM integration.
20 November 2024 in Journal of Lightwave Technology
A record continuous transmission bandwidth of 16.4 THz is demonstrated in O-band fibre transmission over an 80-km single-mode ultra low-loss fibre span. Bismuth-doped fibre amplifiers with an output power of 25 dBm and a low noise figure of 3.6 dB compensate a loss of 80-km fibre span. An O-band wavelength selective switch with a 16.4 THz bandwidth maximises the transmission capability and enabled optimisation of the input spectrum shape to reduce nonlinear interference near zero dispersion, resulting in a potential achievable information rate of over 100 Tb/s to be reached.
13 November 2006 in IEEE Photonics Technology Letters
We have synchronized a 160-GHz optical beat signal with a 40-GHz reference optical pulse train by using an optical phase-locked loop (OPLL). The OPLL consists of an optical beat signal source, comprising a pair of three-electrode distributed feedback laser diodes that works as a voltage controlled oscillator, and an all-optical phase detector based on the two-photon absorption in a silicon avalanche photodiode. Phase-locking operation is confirmed through phase-error measurement and cross-correlation trace measurement. The residual timing jitter of the 160-GHz optical beat signal relative to the reference pulse train, in the bandwidth of 80 MHz, is measured to be as small as 126 fs
14 September 2022 in Journal of Lightwave Technology
Optical amplification techniques using fiber nonlinearities have the potential to cover new bands beyond the C and L-bands. Among nonlinear amplifiers, the phase-sensitive amplifier has a noise figure that can ideally be 0 dB, and it can compensate for the additional noise resulting from the higher losses of new bands compared to C and L-bands in transmission fibers. In this paper, a hybrid amplifier that combines three nonlinear phenomena in highly nonlinear fibers, namely parametric wavelength conversion, Raman amplification, and phase-sensitive amplification, is proposed as a discrete amplifier to achieve sufficient gain in the new band while simultaneously minimizing amplified spontaneous emission (ASE). The combination of these phenomena helped to simplify the overall amplifier by eliminating the need for electrical phased lock loop and aligning the powers of the signal and idler and maximizing the pump power without signal/pump path separation. In addition, the fiber Bragg grating-based phase shifter reduced the total phase of the signals, idlers, and pump close to zero by temperature tuning. The prototype of the hybrid amplifier achieved >25 nm gain bandwidth, approximately 20 dB net gain, and the ASE level was suppressed. The proposed amplifier is suitable for applications in large-scale high-capacity networks, such as metro and long-haul networks.