8 September 2017 in Journal of Lightwave Technology
A scheme for reconfigurable channel slicing and stitching is proposed and experimentally demonstrated. By employing optical nonlinear wave mixing and a coherent frequency comb, a single channel spectrum is sliced and redistributed into fragmented frequency slots, which can be stitched together to recover the original channel at the receiver. This approach is verified through a single channel experiment with the modulation formats of quadrature phase-shift keying and 16 quadrature amplitude modulation. The system exhibits less than 1.5% error-vector-magnitude deterioration and no more than 2 dB optical signal-to-noise ratio penalty, compared to a back-to-back baseline. To demonstrate robustness of the scheme, different parameters of the channel slices are varied, such as relative phase offset, relative amplitude, and the number of slices. A 10-km transmission experiment is also conducted and the additional system penalty is negligible. This scheme is used to experimentally demonstrate fragmented channel bandwidth allocation in a dense 6-channel wavelength-division-multiplexing system. The incoming 20 Gbaud optical channel is successfully reallocated into two fragmented frequency slots and reconstructed at the receiver.
25 May 2021 in IEEE Photonics Technology Letters
We explore the potential of a combination of two fiber parametric wavelength converters and an erbium-doped fiber amplifier to serve as a hybrid amplifier for S-band. We experimentally confirm the validity of a simple quantum model of the wavelength-converter noise figure (NF) and use it to extrapolate the measurement results and find the optimum hybrid amplifier settings. We find that the total NF can be below 6 dB, if the wavelength conversion efficiency of the first stage is above 4 dB. Furthermore, the total NF can be as low as 4 dB, if the conversion efficiency of the first stage is 10 dB or higher. Finally, we estimate the potential impact of pump relative noise on the NF.
1 January 2007 in Applied Physics Letters
Room temperature ferromagnetism of GaMnN thin film is awaked by a mild hydrogenation treatment of a sample synthesized by molecular beam epitaxy. Local environment of Mn atoms is monitored by near edge x-ray absorption fine structure technique. Doped Mn ions are present at substitutional sites of Ga both before and after the hydrogenation. No secondary phase can be detected. Major valency of Mn changes from to by the hydrogenation. The present result supports the model that the ferromagnetism occurs when and are coexistent and holes in the midgap Mn band mediate the magnetic coupling.
14 September 2022 in Journal of Lightwave Technology
Optical amplification techniques using fiber nonlinearities have the potential to cover new bands beyond the C and L-bands. Among nonlinear amplifiers, the phase-sensitive amplifier has a noise figure that can ideally be 0 dB, and it can compensate for the additional noise resulting from the higher losses of new bands compared to C and L-bands in transmission fibers. In this paper, a hybrid amplifier that combines three nonlinear phenomena in highly nonlinear fibers, namely parametric wavelength conversion, Raman amplification, and phase-sensitive amplification, is proposed as a discrete amplifier to achieve sufficient gain in the new band while simultaneously minimizing amplified spontaneous emission (ASE). The combination of these phenomena helped to simplify the overall amplifier by eliminating the need for electrical phased lock loop and aligning the powers of the signal and idler and maximizing the pump power without signal/pump path separation. In addition, the fiber Bragg grating-based phase shifter reduced the total phase of the signals, idlers, and pump close to zero by temperature tuning. The prototype of the hybrid amplifier achieved >25 nm gain bandwidth, approximately 20 dB net gain, and the ASE level was suppressed. The proposed amplifier is suitable for applications in large-scale high-capacity networks, such as metro and long-haul networks.
25 October 2022 in IEEE Photonics Technology Letters
Fabry-Perot (FP) laser diodes usually have multiple longitudinal modes. An optical spectrum analyzer (OSA) is able to measure the average power distribution of the mode structure but cannot detect the dynamics of mode competition which is the origin of the mode partition noise. We demonstrate a time-resolved optical spectrum measurement technique based on frequency-to-time conversion through time gating, chromatic dispersion, and real-time waveform sampling. This allows to investigate the dynamics of mode competition and correlation of relative intensity noises among different FP modes of the diode laser.
27 June 2022 in Journal of Lightwave Technology
We report parametric gain by utilizing $ \chi ^{(2)}$ non-linearities in a semiconductor Bragg Reflection Waveguide (BRW) waveguide chip. Under the two-mode degenerate type II phase matching, it can be shown that more than 18 dBs of parametric gain for both TE and TM modes is tenable in 100 s of micrometers of device length. Polarization insensitive parametric gain can be attained within the 1550 nm region of the spectrum. These AlGaAs BRW waveguides exhibit sub-photon per pulse sensitivity. This is in sharp contrast to other types of parametric gain devices which utilize $ \chi ^{(3)}$ , where the pump wavelength is in the vicinity of the signal wavelength. This sensitivity, which reached 0.1 photon/pulse, can usher a new era for on-chip quantum information processing using compact, micrometer-scale devices.