7 June 2024 in Advanced Functional Materials
Kesterite photovoltaic technologies are critical for the deployment of light‐harvesting devices in buildings and products, enabling energy sustainable buildings, and households. The recent improvements in kesterite power conversion efficiencies have focused on improving solution‐based precursors by improving the material phase purity, grain quality, and grain boundaries with many extrinsic doping and alloying agents (Ag, Cd, Ge…). The reported progress for solution‐based precursors has been achieved due to a grain growth in more electronically intrinsic conditions. However, the kesterite device performance is dependent on the majority carrier density and sub‐optimal carrier concentrations of 10 14 –10 15 cm −3 have been consistently reported. Increasing the majority carrier density by one order of magnitude would increase the efficiency ceiling of kesterite solar cells, making the 20% target much more realistic. In this work, LiClO 4 is introduced as a highly soluble and highly thermally stable Li precursor salt which leads to optimal (>10 16 cm −3 ) carrier concentration without a significant impact in other relevant optoelectronic properties. The findings presented in this work demonstrate that the interplay between Li‐doping and Ag‐alloying enables a reproducible and statistically significant improvement in the device performance leading to efficiencies up to 14.1%.
1 September 2021 in Journal of Power Sources
11 November 2022 in Solar Energy Materials and Solar Cells
7 November 2024 in Journal of Materials Chemistry A
High concentration of Cl − anions in the precursor solution leads to thermally-induced Sn loss during solvent evaporation of precursor layer fabrication. Partial substitution of acetate salts for chloride salts mitigates Sn loss.
13 December 2023 in ACS Applied Energy Materials
Li-alloying of Cu2ZnSn-(S, Se)4 (CZTSSe) absorbers is widely accepted for its beneficial influence on the performance of CZTSSe-based thin film solar cells. Given the degraded morphology characteristic of absorbers synthesized in the presence of excess Li concentrations, it is speculated that Li may be best incorporated into the absorber after synthesis. Here, we report an innovative method to add Li to synthesized CZTSSe by an electrochemical treatment using a liquid electrolyte. Our approach decouples Li addition from absorber synthesis, allowing one to possibly overcome morphology issues associated with high Li concentration. We show that Li is thereby transferred to the absorber and is incorporated into the crystal lattice. The resulting Li concentration in the absorber can be easily controlled by the treatment parameters. Using liquid electrolytes allows a straightforward disassembly of the lithiation setup and hence the fabrication of solar cells after electrochemical treatment. Electrochemically lithiated solar cells reached power conversion efficiencies of up to 9.0%. Further optimization of this innovative method is required to reduce expected interface issues resulting from the electrochemical treatment to demonstrate a gain in the power conversion efficiency of the CZTSSe solar cells. Finally, our results indicate strong lateral Li diffusion, which deserves further investigation. Moreover, the method could be transferred to other material systems, such as Cu-(In, Ga)-Se2 (CIGS), and adapted to treat layers with other alkali elements such as Na.