Kesterite photovoltaic technologies are critical for the deployment of light‐harvesting devices in buildings and products, enabling energy sustainable buildings, and households. The recent improvements in kesterite power conversion efficiencies have focused on improving solution‐based precursors by improving the material phase purity, grain quality, and grain boundaries with many extrinsic doping and alloying agents (Ag, Cd, Ge…). The reported progress for solution‐based precursors has been achieved due to a grain growth in more electronically intrinsic conditions. However, the kesterite device performance is dependent on the majority carrier density and sub‐optimal carrier concentrations of 10 14 –10 15 cm −3 have been consistently reported. Increasing the majority carrier density by one order of magnitude would increase the efficiency ceiling of kesterite solar cells, making the 20% target much more realistic. In this work, LiClO 4 is introduced as a highly soluble and highly thermally stable Li precursor salt which leads to optimal (>10 16 cm −3 ) carrier concentration without a significant impact in other relevant optoelectronic properties. The findings presented in this work demonstrate that the interplay between Li‐doping and Ag‐alloying enables a reproducible and statistically significant improvement in the device performance leading to efficiencies up to 14.1%.
Kesterite Cu2ZnSnSxSe4−x (CZTSSe) is among the most promising inorganic Earth‐abundant thin‐film photovoltaic technologies, although currently, the larger voltage deficit compared with more mature chalcogenide technologies is hampering solar‐to‐electricity conversion efficiency progress in these materials. Most of the latest reports agree on the CZTSSe defect structure as the main limitation for the open‐circuit voltage. Small atom doping is suggested as an interesting strategy to reduce the concentration of defects without affecting secondary phase formation. Herein, an innovative approach based on the introduction of LiAlH4 and its further decomposition during the selenization process of CZTSe precursors, as a pathway for hydrogen and lithium/alkali transient doping, is explored. This process shows a strong beneficial influence on the crystal growth and solar cell device performance, especially with a significant improvement in Voc and fill factor. A reduction of nonradiative recombination and a remarkable fourfold increase in the carrier lifetime correlating with the reduction of the open‐circuit voltage (Voc) deficit below 330 mV is demonstrated. A mechanism on how small atoms (Li and H) interact to reduce the concentration of SnZn recombination centers while keeping doping relatively unchanged is proposed, opening fundamental perspectives for the simple and universal transient doping of thin‐film chalcogenide compounds.
Back contact engineering of flexible (Ag,Cu)2ZnSn(S,Se)4 solar cells on Mo foil was performed. Despite the formation of a thick MoSe2 layer, MoO3 insertion at the back reduced kesterite decomposition and promoted grain growth, enabling η of 11.2%.