17 February 2021 in Journal of Interdisciplinary Mathematics
Robot-assisted surgical procedures have gained much coverage in recent years and favored over manually conducted operations. The medical robots are comprised of manipulators arm that is the multi-degree of freedom positioning devices with a highly non-linear nature to perform various surgical tasks. Due to non-linear effects, robots offer a severe challenge to the control system. Therefore, the control techniques are required for controlling the robots that should be fast enough to accommodate the rapid changes in the system parameters. In this article, the Proportional-Integral-Derivative (PID) controller’s performance has been investigated in trajectory control of the Two-Link Robotic Manipulator (TLRM) for reliable functioning of these robots. Tracking error and Control input factors have been used to investigate the PID controller’s robustness in trajectory control of ‘TLRM.’ Euler’s-lagrange approach has been used for dynamic analysis of ‘TLRM’. This work has been accomplished in the MATLAB®/ Simulink environment.
23 May 2019 in IETE Journal of Research
This paper presents the design and implementation of three-phase four-wire shunt active power filter (SAPF). It consists of insulated gate bipolar transistors, IGBT based current-controlled voltage source inverter (CC-VSI), series coupling inductor and self-supported DC bus. Power electronics based converters and non-linear loads generate waveform-driven power quality issue as harmonics. Three-phase four-wire SAPF mitigates harmonics, compensates for reactive power, neutral current and power factor correction. Conventionally, the positive sequence detection control strategy using phase-locked loop (PLL) is applied as the synchronizing unit vector element to generate reference source currents. Conventional controller tuning process is difficult and fails to perform satisfactorily under supply voltage variation conditions. In this paper, Levenberg-Marquardt back propagation training algorithm based artificial neural network (ANN) controller is proposed to regulate DC link voltage due to its self-adapting and rapid calculation characteristics that allow the controller to handle high nonlinearity and uncertainty in a non-linear system. Weights of a neuron are adapted to minimize total harmonic distortion (THD) of source current under the step, ramp, time series amplitude variation and frequency and amplitude of modulation conditions. The proposed system is modelled in MATLAB/SIMULINK environment and laboratory prototype with dSpace1104 control card is developed. Experimentation results validate the simulated results of the proposed scheme under supply voltage variations for three-phase four-wire distribution system.
13 October 2018 in Engineering, Technology & Applied Science Research
DC-DC converters preserve or control the output DC voltage. Due to parasitic constituents such as leakage capacitance of both diode and inductor, and transformer leakage inductance, DC-DC converters mostly operate on rigid switching conditions which result in high switching losses. These parasitic constituents affect the dc-dc converter’s operational reliability, instigate electromagnetic interference issues and limit the converter’s operation at higher frequency operations. In this paper, resonant or soft-switch approach has been employed to improve the operating performance and design-oriented principle investigations have been carried out for overcoming the issues of parasitic constituents in 24-12V DC-DC step-down (buck) converter. This paper divulges the analysis and Matlab Simulation results for 24-12V buck converter based on resonant or soft-switching approach.
4 October 2015 in Journal of Renewable Energy
Power extension of grid to isolated regions is associated with technical and economical issues. It has encouraged exploration and exploitation of decentralized power generation using renewable energy sources (RES). RES based power generation involves uncertain availability of power source round the clock. This problem has been overcome to certain extent by installing appropriate integrated energy storage unit (ESU). This paper presents technical review of hybrid wind and photovoltaic (PV) generation in standalone mode. Associated components like converters, storage unit, controllers, and optimization techniques affect overall generation. Wind and PV energy are readily available, omnipresent, and expected to contribute major future energy market. It can serve to overcome global warming problem arising due to emissions in fossil fuel based thermal generation units. This paper includes the study of progressive development of standalone renewable generation units based on wind and PV microgrids. Power extension of grid to isolated regions is associated with technical and economical issues. It has encouraged exploration and exploitation of decentralized power generation using renewable energy sources (RES). RES based power generation involves uncertain availability of power source round the clock. This problem has been overcome to certain extent by installing appropriate integrated energy storage unit (ESU). This paper presents technical review of hybrid wind and photovoltaic (PV) generation in standalone mode. Associated components like converters, storage unit, controllers, and optimization techniques affect overall generation. Wind and PV energy are readily available, omnipresent, and expected to contribute major future energy market. It can serve to overcome global warming problem arising due to emissions in fossil fuel based thermal generation units. This paper includes the study of progressive development of standalone renewable generation units based on wind and PV microgrids.