31 July 2015 in Journal of Superconductivity and Novel Magnetism
7 June 2017 in Journal of Superconductivity and Novel Magnetism
We report the electrical (angular magneto-resistance and Hall), thermal (heat capacity) and spectroscopic (Raman, X-ray photoelectron, angle-resolved photoelectron) characterization of a bulk Bi2Se3 topological insulator, which was grown by self-flux method through solid-state reaction from high-temperature (950∘C) melt and slow cooling (2∘C/h) of constituent elements. Bi2Se3 exhibited metallic behaviour down to 5 K. Magneto-transport measurements revealed linear up to 400 and 30% magneto-resistance (MR) at 5 K under a 14-T field in perpendicular and parallel field directions, respectively. We noticed that the MR of Bi2Se3 is very sensitive to the angle of the applied field. The MR is maximum when the field is normal to the sample surface, while it is minimum when the field is parallel. The Hall coefficient (RH) is seen nearly invariant with a negative carrier sign down to 5 K albeit having near-periodic oscillations above 100 K. The heat capacity (Cp) versus temperature plot is seen without any phase transitions down to 5 K and is well fitted (Cp = γT + βT3) at low temperature with a calculated Debye temperature (????D) value of 105.5 K. Clear Raman peaks are seen at 72, 131 and 177 cm−1 corresponding to A\(_{\mathrm {1g}}^{1}\), E\(_{\mathrm {g}}^{2}\) and A\(_{1\mathrm {g}}^{2}\), respectively. Though two distinct asymmetric characteristic peak shapes are seen for Bi 4f7/2 and Bi 4f5/2, the Se 3d region is found to be broad, displaying the overlapping of spin-orbit components of the same. Angle-resolved photoemission spectroscopy (ARPES) data of Bi2Se3 revealed distinctly the bulk conduction bands (BCB), surface state (SS), Dirac point (DP) and bulk valence bands (BVB), and 3D bulk conduction signatures are clearly seen. Summarily, a host of physical properties for the as-grown Bi2Se3 crystal are reported here.
1 September 2015 in AIP Advances
We report successful growth of flux free large single crystals of superconducting FeSe1/2Te1/2 with typical dimensions of up to few cm. The AC and DC magnetic measurements revealed the superconducting transition temperature (Tc) value of around 11.5K and the isothermal MH showed typical type-II superconducting behavior. The lower critical field (Hc1) being estimated by measuring the low field isothermal magnetization in superconducting regime is found to be above 200Oe at 0K. The temperature dependent electrical resistivity ρ(T ) showed the Tc (onset) to be 14K and the Tc(ρ = 0) at 11.5K. The electrical resistivity under various magnetic fields i.e., ρ(T)H for H//ab and H//c demonstrated the difference in the width of Tc with applied field of 14Tesla to be nearly 2K, confirming the anisotropic nature of superconductivity. The upper critical and irreversibility fields at absolute zero temperature i.e., Hc2(0) and Hirr(0) being determined by the conventional one-band Werthamer–Helfand–Hohenberg (WHH) equation for the criteria of normal state resistivity (ρn) falling to 90% (onset), and 10% (offset) is 76.9Tesla, and 37.45Tesla respectively, for H//c and 135.4Tesla, and 71.41Tesla respectively, for H//ab. The coherence length at the zero temperature is estimated to be above 20Å ´ by using the Ginsburg-Landau theory. The activation energy for the FeSe1/2Te1/2 in both directions H//c and H//ab is determined by using Thermally Activation Flux Flow (TAFF) model.
1 November 2017 in AIP Advances
Point defect pinning centers are the key factors responsible for the flux pinning and critical current density in type II superconductors. The introduction of the point defects and increasing their density without any changes to the superconducting transition temperature Tc, irreversibility field Hirr, and upper critical field Hc2, would be ideal to gain insight into the intrinsic point-defect-induced pinning mechanism. In this work, we present our investigations on the critical current density Jc, Hc2, Hirr, the activation energy U0, and the flux pinning mechanism in Fe1-xCoxSe0.5Te0.5 (x = 0, 0.03 and 0.05) single crystals. Remarkably, we observe that the Jc and U0 are significantly enhanced by up to 12 times and 4 times for the 3at.% Co-doped sample, whereas, there is little change in Tc, Hirr, and Hc2. Furthermore, charge-carrier mean free path fluctuation, δl pinning, is responsible for the pinning mechanism in Fe1-xCoxSe0.5Te0.5.
11 January 2018 in Superconductor Science and Technology
We performed a systematic study of the hydrostatic pressure (HP) effect on the supercon-ducting transition temperature ( T c ), critical current density ( J c ), irreversibility field ( H irr ), upper critical field ( H c2 ), and flux pinning mechanism in un-doped and 3 at.% Co-doped FeSe 0.5 Te 0.5 crystals. We found that T c is increased from 11.5 to 17 K as HP increases from 0 to 1.2 GPa. Remarkably, the J c is significantly enhanced by a factor of 3 to 100 for low and high temperature and field, and the H irr line is shifted to higher fields by HP up to 1.2 GPa. Based on the collective pinning model, the δl pinning associated with charge-carrier mean free path fluctuation is responsible for the pinning mechanism of Fe
1−
x
Co
x
Se 0.5 Te 0.5 samples with or without pressure. A comprehensive vortex phase diagram in the mixed state is constructed and analysed for the 3 at.% Co-doped sample.
24 May 2016 in Physical Review B
Using angle-resolved photoemission spectroscopy (ARPES), we studied the effect of the impurity potential on the electronic structure of superconductor by substituting 10% of Ni for Fe, which leads to an electron doping of the system. We could resolve three hole pockets near the zone center and an electron pocket near the zone corner in the case of , whereas only two hole pockets near the zone center and an electron pocket near the zone corner are resolved in the case of , suggesting that the hole pocket having predominantly the orbital character is very sensitive to the impurity scattering. Upon electron doping, the size of the hole pockets decreases and the size of the electron pockets increases as compared to the host compound. However, the observed changes in the size of the electron and hole pockets are not consistent with the rigid-band model. Moreover, the effective mass of the hole pockets is reduced near the zone center and of the electron pockets is increased near the zone corner in the doped as compared to . We refer these observations to the changes of the spectral function due to the effect of the impurity potential of the dopants.