1 March 2018 in Journal of Applied Geophysics
19 October 2021 in Geophysical Journal International
We present a solution for long-term direct current resistivity and time-domain induced polarization (DCIP) monitoring, which consists of a monitoring system and the associated software that automates the data collection and processing. This paper describes the acquisition system that is used for remote data collection and then introduces the routines that have been developed for pre-processing of the monitoring data set. The collected data set is pre-processed using digital signal processing algorithms for outlier detection and removal; the resulting data set is then used for the inversion procedure. The suggested processing workflow is tested against a simulated time-lapse experiment and then applied to field data. The results from the simulation show that the suggested approach is very efficient for detecting changes in the subsurface; however, there are some limitations when no a priori information is used. Furthermore, the mean weekly data sets that are generated from the daily collected data can resolve low-frequency changes, making the approach a good option for monitoring experiments where slow changes occur (i.e. leachates in landfills, internal erosion in dams, bioremediation). The workflow is then used to process a large data set containing 20 months of daily monitoring data from a field site where a pilot test of in situ bioremediation is taking place. Based on the time-series analysis of the inverted data sets, we can detect two portions of the ground that show different geophysical properties and that coincide with the locations where the different fluids were injected. The approach that we used in this paper provides consistency in the data processing and has the possibility to be applied to further real-time geophysical monitoring in the future.
13 February 2024 in Science of The Total Environment
Pollutions on and within the underground poses risks for groundwater contamination and is a widespread global problem. Common remediation methods based on digging and removal can be expensive and have limitations, while in-situ remediation is an attractive alternative. However, there is a need to develop tools to monitor the effectiveness both in terms of the successful injection of remediation fluids but also the effectiveness of the treatment, i.e., degree of degradation/removal of the pollutants and possible metabolites. This paper presents a methodology for monitoring the changes following an in-situ remediation treatment of a site contaminated with chlorinated solvents. The methodology consists of two different methods, where Direct Current resistivity and time-domain Induced Polarization (DCIP) was used to acquire daily data and geochemical analyses on water samples were collected approximately every three months. The geophysical results provide insights on how the injected fluids are spreading and assist in acquiring a better understanding of the geological and hydrogeological system. On the other hand, the geochemical sampling enhances our knowledge about the hydrochemistry of the system and the concentration of the pollutants. Our research highlights the challenges of monitoring in-situ bioremediation experiments in complex environments and in cases where pollutants are situated in low hydraulic conductivity formations. The joint interpretation of the data shows the importance of an interdisciplinary approach to understand complex systems.