Johannes Landesfeind

Johannes Landesfeind

Auto-generated profile, based on publicly available information

Johannes Landesfeind

University of Agder

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 April 2016 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JLJohannes Landesfeind
Johannes Landesfeind
JHJohannes Hattendorff
Johannes Hattendorff
AEAndreas Ehrl
Andreas Ehrl
WWWolfgang A. Wall
Wolfgang A. Wall
HGHubert A. Gasteiger
Hubert A. Gasteiger
Lithium ion battery performance at high charge/discharge rates is largely determined by the ionic resistivity of an electrode and separator which are filled with electrolyte. Key to understand and to model ohmic losses in porous battery components is porosity as well as tortuosity. In the first part, we use impedance spectroscopy measurements in a new experimental setup to obtain the tortuosities and MacMullin numbers of some commonly used separators, demonstrating experimental errors of <8%. In the second part, we present impedance measurements of electrodes in symmetric cells using a blocking electrode configuration, which is obtained by using a non-intercalating electrolyte. The effective ionic resistivity of the electrode can be fit with a transmission-line model, allowing us to quantify the porosity dependent MacMullin numbers and tortuosities of electrodes with different active materials and different conductive carbon content. Best agreement between the transmission-line model and the impedance data is found when constant-phase elements rather than simple capacitors are used.

13 September 2019 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JLJohannes Landesfeind
Johannes Landesfeind
HGHubert A. Gasteiger
Hubert A. Gasteiger
Lithium-ion battery performance at low temperatures or fast charge/discharge rates is determined by the intrinsic electrolyte transport and the thermodynamic properties of the commonly used binary electrolytes. For the development of future electrolyte solutions, a quantification of the ionic conductivity, the binary diffusion coefficient, the transference number, and the thermodynamic factor over a large concentration and temperature range is mandatory. In this study, we apply previously discussed and established methods for the determination of ionic conductivities and binary diffusion coefficients to two commonly used electrolyte systems (EC:DMC (1:1 w:w) and EC:EMC (3:7 w:w)) as well as to one EC-free electrolyte (EMC:FEC (19:1 w:w)). To quantify transference numbers and thermodynamic factors, we introduce a novel analysis scheme, so that we are ultimately able to report temperature (−10°C–+50°C) and concentration (0.1 M–3.0 M) dependent values as well as approximate relationships for transport and thermodynamic properties required for numerical battery models. Comparison with scarcely available literature data highlights that the hitherto reported concentration and temperature dependencies do not reflect the complexity of ionic transport properties, which will likely lead to imprecise predictions of, e.g., a lithium-ion battery's power limitations or the onset of lithium plating.

19 August 2016 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
SSSophie Solchenbach
Sophie Solchenbach
DPDaniel Pritzl
Daniel Pritzl
EKEdmund Jia Yi Kong
Edmund Jia Yi Kong
JLJohannes Landesfeind
Johannes Landesfeind
HGHubert A. Gasteiger
Hubert A. Gasteiger
Impedance measurements of lithium-ion batteries are a powerful tool to investigate the electrolyte/electrode interface. To separate the contributions of anode and cathode to the full-cell impedance, a reference electrode is required. However, if the reference electrode is placed inappropriately, the impedance response can easily be biased and lead to erroneous conclusions. In this study, we present a novel micro-reference electrode for Swagelok-type T-cells which is suitable for long-term impedance and reference potential measurements. The reference electrode consists of a thin insulated gold wire, which is placed centrally between cathode and anode and is in-situ electrochemically alloyed with lithium. The resulting lithium-gold alloy reference electrode shows remarkable stability (>500 h) even during cycling or at elevated temperatures (40°C). The accuracy of impedance measurements with this novel reference electrode is carefully validated. Further, we investigate the effect of different vinylene carbonate (VC) contents in the electrolyte on the charge transfer resistance of LFP/graphite full cells and demonstrate that the ratio of VC to active material, rather than the VC concentration, determines the impedance of the anode SEI.

8 February 2018 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JLJohannes Landesfeind
Johannes Landesfeind
MEMartin Ebner
Martin Ebner
AEAskin Eldiven
Askin Eldiven
VWVanessa Wood
Vanessa Wood
HGHubert A. Gasteiger
Hubert A. Gasteiger
Tortuosity values of porous battery electrodes determined using electrochemical impedance spectroscopy in symmetric cells with a non-intercalating electrolyte are typically higher than those values based on numerical analysis of 3D tomographic reconstructions. The electrochemical approach assumes that the electronic resistance in the porous coating is negligible and that the tortuosity of the porous electrode can be calculated from the ionic resistance determined by fitting a transmission line equivalent circuit model to the experimental data. In this work, we validate the assumptions behind the electrochemical approach. First, we experimentally and theoretically investigate the influence of the electronic resistance of the porous electrode on the extracted ionic resistances using a general transmission line model, and provide a convenient method to determine whether the electronic resistance is sufficiently low for the model to be correctly applied. Second, using a macroscopic setup with known tortuosity, we prove that the ionic resistance quantified by the transmission line model indeed yields the true tortuosity of a porous medium. Based on our findings, we analyze the tortuosities of porous electrodes using both X-ray tomography and electrochemical impedance spectroscopy on electrodes from the same coating and conclude that the distribution of the polymeric binder phase, which is not imaged in most tomographic experiments, is a key reason for the underestimated tortuosity values calculated from 3D reconstructions of electrode microstructures.

2 June 2017 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JLJohannes Landesfeind
Johannes Landesfeind
DPDaniel Pritzl
Daniel Pritzl
HGHubert A. Gasteiger
Hubert A. Gasteiger
A key for the interpretation of porous lithium ion battery electrode impedance spectra is a meaningful and physically motivated equivalent-circuit model. In this work we present a novel approach, utilizing a general transmission line equivalent-circuit model to exemplarily analyze the impedance of a porous high-voltage LiNi0.5Mn1.5O4 (LNMO) cathode. It is based on a LNMO/graphite full-cell setup equipped with a gold wire micro-reference electrode (GWRE) to obtain impedance spectra in both, non-blocking conditions at a potential of 4.4 V cell voltage and in blocking configuration achieved at 4.9 V cell voltage. A simultaneous fitting of both spectra enables the deconvolution of physical effects to quantify over the course of 85 cycles at 40°C: a) the true charge transfer resistance (RCT), b) the pore resistance (RPore), and c) the contact resistance (RCont.). We demonstrate that the charge transfer resistance would be overestimated significantly, if the spectra are fitted with a conventionally used simplified R/Q equivalent-circuit compared to our full transmission line analysis.

15 March 2018 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
JLJohannes Landesfeind
Johannes Landesfeind
AEAskin Eldiven
Askin Eldiven
HGHubert A. Gasteiger
Hubert A. Gasteiger
The electrochemical performance of porous graphite anodes in lithium ion battery applications is limited by the lithium ion concentration gradients in the liquid electrolyte, especially at high current densities and for thick coatings during battery charging. Beside the electrolyte transport parameters, the porosity and the tortuosity of the coating are key parameters that determine the electrode's suitability for high power applications. Here, we investigate the tortuosity of graphite anodes using two water as well as three n-methyl-2-pyrrolidone based binder systems by analysis of symmetric cell impedance measurements, demonstrating that tortuosities ranging from ∼3–10 are obtained for graphite anodes of similar thickness (∼100 μm), porosities (∼50%) and areal capacity (∼3.4 mAh/cm2). Furthermore, selected electrodes with tortuosities of 3.1, 4.3, and 10.2 were cycled in cells with reference electrode at charging C-rates from 0.1-20 1/h, illustrating the clear correlation between electrode tortuosity and its rate capability.