Yingfu He

Yingfu He

Auto-generated profile, based on publicly available information

Yingfu He

Sinopec Petroleum Exploration and Production Research Institute

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 January 2021 in Energy Exploration & Exploitation
Verified
Journal Article
Open access
PDF file
QZQi Zhang
Qi Zhang
XWXinyue Wu
Xinyue Wu
YHYingfu He
Yingfu He
QMQingbang Meng
Qingbang Meng
Spontaneous imbibition is an important mechanism of oil recovery from fractured reservoirs and unconventional reservoirs. Oil is produced by combining co- and counter-current imbibition when the matrix blocks was partially covered by water. In this paper, we focused on the effect of viscosity ratios on oil production by spontaneous imbibition and established the numerical model for one-dimensional linear imbibition with TEO-OW boundary conditions, which was validated by the experimental data. The effect of viscosity ratio on co- and counter-current imbibition is investigated and scaling result of the imbibition recovery curve for wide range of viscosity ratio using the conventional scaling equation was tested, which indicates that the close correlation was achieved only when oil-water viscosity ratios are higher. Then, a modified scaling equation was developed based on the piston-like assumption for one-dimensional co-current imbibition and close correlation of imbibition recovery curves was achieved when viscosity ratios are lower. Finally, correlation of imbibition recovery curves was improved for wide range of viscosity ratios by combining conventional and modified scaling equation. Results show that since the shape of imbibition recovery curves is not similar for different viscosity ratios, it is difficult to obtain the perfect correlation using the constant viscosity term.

21 February 2022
Verified
Conference Paper
Closed access
PDF file
TXTing Xu
Ting Xu
HLHaiying Liao
Haiying Liao
YHYingfu He
Yingfu He
JNJun Nie
Jun Nie
MCMaolei Cui
Maolei Cui
YGYabing Guo
Yabing Guo
Northwest oilfield M reservoir is deep block sandstone reservoir with strong aquifer, having thin layer, large water-oil volume ratio, high temperature and salinity, strong heterogeneity, being developed more than 20 years by depletion method, influenced by bottom water, reservoir comes into high water cut period, recovery degree is only 26%, requiring for further enhanced oil recovery technology. CO2 is easily miscible with oil, but whether CO2 is applicable for the reservoir with strong aquifer or not is still unclear. No foundation can be referred to in area optimization for CO2 flooding. It is necessary to conduct research on influencing factors of CO2 flooding in the sandstone reservoir with aquifer and set up the favorable target optimization technology. Reservoir engineering method was applied to study M reservoir production pattern. Based on G&G, the geological-dynamic response law was established and productivity influencing factors were studied. Considering flowing differences between block reservoir and layered reservoir, the flowing field is affected by vertical sweep of bottom water, internal small faults have sealing effect on plane sweep, development unit division method was formed on the basis of vertical hydrodynamic characteristics. According to CO2 occurrence state and dynamic distribution in oil layer and strong aquifer, three types of favorable target have been classified, favorable target optimization technology is established for CO2 flooding in deep block sandstone reservoir with strong aquifer. Research results show that the south and middle block are structurally high, edge water intrusion is weak, main layer is relatively thick and interlayer is developed, I and II type well are the main production well. While the north block is structurally low, reservoir quality is poorer, II and III type wells amount a lot. CO2 density is higher than the oil, in the interlayer undeveloped block, CO2 migrates vertically to the oil-water interface, then spreads laterally forced by bottom water, resulting in an increase in the oil-water interface tension and a decrease in the diffusion rate to the water. The more developed the interlayer is, the larger the sweep volume of CO2 is. In high structural position, fault sealing, interlayer developed and thick layer, the enrichment degree of remaining oil is still high, important to ensure CO2 lateral sweep. As results, favorable target for CO2 flooding is classified into I, II and III type. CO2 flooding pilot test was carried out in type I favorable target. Till now, 18,000 tons of CO2 had been injected, oil exchange ratio in 1st year was 0.13. Research results lay the foundation for the efficient utilization of the remaining oil, so as to explore an effective development method for deep, ultra-deep sandstone reservoir to greatly enhanced oil recovery.

2 November 2026 in ACS Omega
Verified
Journal Article
Open access
MYMingyang Yang
Mingyang Yang
ZYZhengmao Yang
Zhengmao Yang
YHYingfu He
Yingfu He
SFSidong Fang
Sidong Fang
JMJunwei Mei
Junwei Mei
XXXiaofei Xiong
Xiaofei Xiong
CO2 huff-n-puff (HnP) is an established enhanced oil recovery (EOR) method for shale oil reservoirs. However, its field-scale implementation in multiwell fractured systems remains challenging because fracture-controlled interwell connectivity can cause operational interference and inefficient CO2 allocation. A field-scale numerical model of the HH shale oil reservoir, incorporating complex natural and hydraulic fracture networks, was constructed and history-matched against field production data, followed by a structured sequential one-factor-at-a-time analysis and descriptive Spearman rank-correlation screening of the associations between operational parameters and performance indicators. Results indicate that, for the calibrated HH reservoir realization, the intragroup synchronized and intergroup asynchronous strategy achieved the highest cumulative incremental oil production among the investigated strategies (9.59 × 104 t), together with a CO2 utilization efficiency of 0.266 t oil/t CO2. This performance was associated with the cross-group pressure contrast observed under the asynchronous operation of the two well groups. Rank-correlation screening indicated that cycle number and cyclic CO2 injection mass showed the strongest associations with oil recovery and CO2 utilization efficiency, respectively, within the investigated cases. Within the investigated ranges and under the experimentally constrained diffusion setting of the calibrated HH reservoir model, 45 days and 450 t/d were identified as the preferred soaking time and injection rate, respectively. Extending the soaking time from 45 to 55 days yielded only marginal improvements, whereas increasing the injection rate from 450 to 600 t/d slightly reduced both incremental oil production and CO2 utilization efficiency. Furthermore, compared with the uniform injection scheme, the differentiated injection scheme maintained a comparable OOIP-based recovery factor (15.97% versus 15.84%) while reducing the cumulative gross CO2 injection mass from 36.0 × 104 to 33.1 × 104 t, corresponding to an 8.1% reduction. The EOR-oriented CO2 utilization efficiency consequently increased from 0.274 to 0.305 t oil/t CO2. Therefore, its principal benefit was the more efficient use of the injected CO2 rather than a substantial increase in ultimate oil recovery. This work provides a field-scale numerical workflow for designing and evaluating coordinated multiwell CO2 HnP operations in fractured shale oil reservoirs.