20 November 2017 in Nature Photonics
20 November 2018 in Nature Communications
Hybrid perovskite semiconductors represent a promising platform for color-tunable light emitting diodes (LEDs) and lasers; however, the behavior of these materials under the intense electrical excitation required for electrically-pumped lasing remains unexplored. Here, we investigate methylammonium lead iodide-based perovskite LEDs under short pulsed drive at current densities up to 620 A cm−2. At low current density (J < 10 A cm−2), we find that the external quantum efficiency (EQE) depends strongly on the time-averaged history of the pulse train and show that this curiosity is associated with slow ion movement that changes the internal field distribution and trap density in the device. The impact of ions is less pronounced in the high current density regime (J > 10 A cm−2), where EQE roll-off is dominated by a combination of Joule heating and charge imbalance yet shows no evidence of Auger loss, suggesting that operation at kA cm−2 current densities relevant for a laser diode should be within reach.
22 July 2021 in Journal of Applied Physics
We demonstrate ferroelectricity in Mg-substituted ZnO thin films with the wurtzite structure. Zn1−xMgxO films are grown by dual-cathode reactive magnetron sputtering on (111)-Pt // (0001)-Al2O3 substrates at temperatures ranging from 26 to 200 °C for compositions spanning from x = 0 to x = 0.37. X-ray diffraction indicates a decrease in the c-lattice parameter and an increase in the a-lattice parameter with increasing Mg content, resulting in a nearly constant c/a axial ratio of 1.595 over this composition range. Transmission electron microscopy studies show abrupt interfaces between Zn1−xMgxO films and the Pt electrode. When prepared at pO2 = 0.025, film surfaces are populated by abnormally oriented grains as measured by atomic force microscopy for Mg concentrations >29%. Raising pO2 to 0.25 eliminates the misoriented grains. Optical measurements show increasing bandgap values with increasing Mg content. When prepared on a 200 °C substrate, films display ferroelectric switching with remanent polarizations exceeding 100 μC cm−2 and coercive fields below 3 MV cm−1 when the Mg content is between ∼30% and ∼37%. Substrate temperature can be lowered to ambient conditions, and when doing so, capacitor stacks show only minor sacrifices to crystal orientation and nearly identical remanent polarization values; however, coercive fields drop below 2 MV/cm. Using ambient temperature deposition, we demonstrate ferroelectric capacitor stacks integrated directly with polymer substrate surfaces.
18 May 2021 in The Journal of Chemical Physics
One of the most exciting and debated aspects of polariton chemistry is the possibility that chemical reactions can be catalyzed by vibrational strong coupling (VSC) with confined optical modes in the absence of external illumination. Here, we report an attempt to reproduce the enhanced rate of cyanate ion hydrolysis reported by Hiura et al. [chemRxiv:7234721 (2019)] when the collective OH stretching vibrations of water (which is both the solvent and a reactant) are strongly coupled to a Fabry–Pérot cavity mode. Using a piezo-tunable microcavity, we reproduce the reported vacuum Rabi splitting but fail to observe any change in the reaction rate as the cavity thickness is tuned in and out of the strong coupling regime during a given experiment. These findings suggest that there are subtleties involved in successfully realizing VSC-catalyzed reaction kinetics and therefore motivate a broader effort within the community to validate the claims of polariton chemistry in the dark.
13 October 2014 in Applied Physics Letters
We report optically pumped random lasing in planar methylammonium lead iodide perovskite microcrystal networks that form spontaneously from spin coating. Low thresholds (<200 μJ/cm2) and narrow linewidths (Δλ < 0.5 nm) reflect lasing from closed quasi-modes that result from ballistic waveguiding in linear network segments linked by scattering at the junctions. Spatio-spectral imaging indicates that these quasi-modes extend over lateral length scales >100 μm and spatially overlap with one another, resulting in chaotic pulse-to-pulse intensity fluctuations due to gain competition. These results demonstrate this class of hybrid organic-inorganic perovskite as a platform to study random lasing with well-defined, low-level disorder, and support the potential of these materials for use in semiconductor laser applications.
30 April 2020 in Physical Review Letters
We investigate the potential for cavity-modified electron transfer in a doped organic semiconductor through the photocurrent that arises from exciting charged molecules (polarons). When the polaron optical transition is strongly coupled to a Fabry-Perot microcavity mode, we observe polaron polaritons in the photoconductivity action spectrum and find that their magnitude depends differently on applied electric field than photocurrent originating from the excitation of uncoupled polarons in the same cavity. Crucially, moving from positive to negative detuning causes the upper and lower polariton photocurrents to swap their field dependence, with the more polaronlike branch resembling that of an uncoupled excitation. These observations are understood on the basis of a phenomenological model in which strong coupling alters the Onsager dissociation of polarons from their dopant counterions by effectively increasing the thermalization length of the photoexcited charge carrier.