1 October 2019 in Atmospheric Measurement Techniques
Methane (CH4) emissions from coal production amount to roughly one-third of European anthropogenic CH4 emissions in the atmosphere. Poland is the largest hard coal producer in the European Union with the Polish side of the Upper Silesian Coal Basin (USCB) as the main part of it. Emission estimates for CH4 from the USCB for individual coal mine ventilation shafts range between 0.03 and 20 kt a−1, amounting to a basin total of roughly 440 kt a−1 according to the European Pollutant Release and Transfer Register (E-PRTR, http://prtr.ec.europa.eu/, 2014). We mounted a ground-based, portable, sun-viewing FTS (Fourier transform spectrometer) on a truck for sampling coal mine ventilation plumes by driving cross-sectional stop-and-go patterns at 1 to 3 km from the exhaust shafts. Several of these transects allowed for estimation of CH4 emissions based on the observed enhancements of the column-averaged dry-air mole fractions of methane (XCH4) using a mass balance approach. Our resulting emission estimates range from 6±1 kt a−1 for a single shaft up to 109±33 kt a−1 for a subregion of the USCB, which is in broad agreement with the E-PRTR reports. Three wind lidars were deployed in the larger USCB region providing ancillary information about spatial and temporal variability of wind and turbulence in the atmospheric boundary layer. Sensitivity studies show that, despite drawing from the three wind lidars, the uncertainty of the local wind dominates the uncertainty of the emission estimates, by far exceeding errors related to the XCH4 measurements themselves. Wind-related relative errors on the emission estimates typically amount to 20 %.
5 May 2022 in Atmospheric Chemistry and Physics
Given its abundant coal mining activities, the Upper Silesian Coal Basin (USCB) in southern Poland is one of the largest sources of anthropogenic methane (CH4) emissions in Europe. Here, we report on CH4 emission estimates for coal mine ventilation facilities in the USCB. Our estimates are driven by pairwise upwind–downwind observations of the column-average dry-air mole fractions of CH4 (XCH4) by a network of four portable, ground-based, sun-viewing Fourier transform spectrometers of the type EM27/SUN operated during the CoMet campaign in May–June 2018. The EM27/SUN instruments were deployed in the four cardinal directions around the USCB approximately 50 km from the center of the basin. We report on six case studies for which we inferred emissions by evaluating the mismatch between the observed downwind enhancements and simulations based on trajectory calculations releasing particles out of the ventilation shafts using the Lagrangian particle dispersion model FLEXPART. The latter was driven by wind fields calculated by WRF (Weather Research and Forecasting model) under assimilation of vertical wind profile measurements of three co-deployed wind lidars. For emission estimation, we use a Phillips–Tikhonov regularization scheme with the L-curve criterion. Diagnosed by the emissions averaging kernels, we find that, depending on the catchment area of the downwind measurements, our ad hoc network can resolve individual facilities or groups of ventilation facilities but that inspecting the emissions averaging kernels is essential to detect correlated estimates. Generally, our instantaneous emission estimates range between 80 and 133 kt CH4 a−1 for the southeastern part of the USCB and between 414 and 790 kt CH4 a−1 for various larger parts of the basin, suggesting higher emissions than expected from the annual emissions reported by the E-PRTR (European Pollutant Release and Transfer Register). Uncertainties range between 23 % and 36 %, dominated by the error contribution from uncertain wind fields.
6 September 2021 in Atmospheric Chemistry and Physics
Methane (CH4) emissions from human activities are a threat to the resilience of our current climate system. The stable isotopic composition of methane (δ13C and δ2H) allows us to distinguish between the different CH4 origins. A significant part of the European CH4 emissions, 3.6 % in 2018, comes from coal extraction in Poland, the Upper Silesian Coal Basin (USCB) being the main hotspot. Measurements of CH4 mole fraction (χ(CH4)), δ13C, and δ2H in CH4 in ambient air were performed continuously during 6 months in 2018 and 2019 at Krakow, Poland, in the east of the USCB. In addition, air samples were collected during parallel mobile campaigns, from multiple CH4 sources in the footprint area of the continuous measurements. The resulting isotopic signatures from sampled plumes allowed us to distinguish between natural gas leaks, coal mine fugitive emissions, landfill and sewage, and ruminants. The use of δ2H in CH4 is crucial to distinguish the fossil fuel emissions in the case of Krakow because their relatively depleted δ13C values overlap with the ones of microbial sources. The observed χ(CH4) time series showed regular daily night-time accumulations, sometimes combined with irregular pollution events during the day. The isotopic signatures of each peak were obtained using the Keeling plot method and generally fall in the range of thermogenic CH4 formation – with δ13C between −59.3 ‰ and −37.4 ‰ Vienna Pee Dee Belemnite (V-PDB) and δ2H between −291 ‰ and −137 ‰ Vienna Standard Mean Ocean Water (V-SMOW). They compare well with the signatures measured for gas leaks in Krakow and USCB mines. The CHIMERE transport model was used to compute the CH4 and isotopic composition time series in Krakow, based on two emission inventories. The magnitude of the pollution events is generally underestimated in the model, which suggests that emission rates in the inventories are too low. The simulated isotopic source signatures, obtained with Keeling plots on each simulated peak, indicate that a higher contribution from fuel combustion sources in the EDGAR v5.0 inventory would lead to a better agreement than when using CAMS-REG-GHG v4.2 (Copernicus Atmosphere Monitoring Service REGional inventory for Air Pollutants and GreenHouse Gases). The isotopic mismatches between model and observations are mainly caused by uncertainties in the assigned isotopic signatures for each source category and the way they are classified in the inventory. These uncertainties are larger for emissions close to the study site, which are more heterogenous than the ones advected from the USCB coal mines. Our isotope approach proves to be very sensitive in this region, thus helping to evaluate emission estimates.
23 September 2022 in Earth System Science Data
Recent climate change mitigation strategies rely on the reduction of methane (CH4) emissions. Carbon and hydrogen isotope ratio (δ13C and δ2H ) measurements can be used to distinguish sources and thus to understand the CH4 budget better. The CH4 emission estimates by models are sensitive to the isotopic signatures assigned to each source category, so it is important to provide representative estimates of the different CH4 source isotopic signatures worldwide. We present new measurements of isotope signatures of various, mainly anthropogenic, CH4 sources in Europe, which represent a substantial contribution to the global dataset of source isotopic measurements from the literature, especially for δ2H . They improve the definition of δ13C from waste sources, and demonstrate the use of δ2H for fossil fuel source attribution. We combined our new measurements with the last published database of CH4 isotopic signatures and with additional literature, and present a new global database. We found that microbial sources are generally well characterised. The large variability in fossil fuel isotopic compositions requires particular care in the choice of weighting criteria for the calculation of a representative global value. The global dataset could be further improved by measurements from African, South American, and Asian countries, and more measurements from pyrogenic sources. We improved the source characterisation of CH4 emissions using stable isotopes and associated uncertainty, to be used in top-down studies. We emphasise that an appropriate use of the database requires the analysis of specific parameters in relation to source type and the region of interest. The final version of the European CH4 isotope database coupled with a global inventory of fossil and non-fossil δ13C and δ2H source signature measurements is available at https://doi.org/10.24416/UU01-YP43IN (Menoud et al., 2022 a).
21 December 2023 in Atmospheric Chemistry and Physics
Anthropogenic emissions are the primary source of the increase in atmospheric methane (CH4) levels. However, estimates of anthropogenic CH4 emissions still show large uncertainties at global and regional scales. Differences in CH4 isotopic source signatures δ13C and δ2H can help to constrain different source contributions (e.g., fossil, waste, agriculture). The Upper Silesian Coal Basin (USCB) represents one of the largest European CH4 emission regions, with more than 500 Gg CH4 yr−1 released from more than 50 coal mine ventilation shafts, landfills, and wastewater treatment plants. During the CoMet (Carbon Dioxide and Methane Mission) campaign in June 2018 methane observations were conducted from a variety of platforms including aircraft and cars to quantify these emissions. Besides the continuous sampling of atmospheric methane concentration, numerous air samples were taken from inside and around the ventilation shafts (1–2 km distance) and aboard the High Altitude and Long Range Research Aircraft (HALO) and DLR Cessna Caravan aircraft, and they were analyzed in the laboratory for the isotopic composition of CH4. The airborne samples downwind of the USCB contained methane from the entire region and thus enabled determining the mean signature of the USCB accurately. This mean isotopic signature of methane emissions was ‰ for δ13C and ‰ for δ2H. This is in the range of previous USCB studies based on samples taken within the mines for δ13C but more depleted in δ2H than reported before. Signatures of methane enhancements sampled upwind of the mines and in the free troposphere clearly showed the influence of biogenic sources. We determined the source signatures of individual coal mine ventilation shafts using ground-based samples. These signatures displayed a considerable range between different mines and also varied for individual shafts from day to day. Different layers of the USCB coal contain thermogenic methane, isotopically similar to natural gas, and methane formed through biogenic carbonate reduction. The signatures vary depending on what layer of coal is mined at the time of sampling. Mean shaft signatures range from −60 ‰ to −42 ‰ for δ13C and from −200 ‰ to −160 ‰ for δ2H. A gradient in the signatures of subregions of the USCB is reflected both in the aircraft data and in the ground samples, with emissions from the southwest being most depleted in δ2H and emissions from the south being most depleted in δ13C, which is probably associated with the structural and lithostratigraphic history of the USCB and generation and migration processes of methane in the coal. The average signature of ‰ in δ13C and ‰ in δ2H from the ventilation shafts clearly differs from the USCB regional signature in δ2H. This makes a source attribution using δ2H signatures possible, which would not be possible with only the δ13C isotopic signatures. We assume that the USCB plume mainly contains fossil coal mine methane and biogenic methane from waste treatment, because the USCB is a highly industrialized region with few other possible methane sources. Assuming a biogenic methane signature between and −320 ‰ and −280 ‰ for δ2H, the biogenic methane emissions from the USCB account for 15 %–50 % of total emissions. The uncertainty range shows the need of comprehensive and extensive sampling from all possible source sectors for source apportionment. The share of anthropogenic–biogenic emissions of 0.4 %–14 % from this densely populated industrial region is underestimated in commonly used emission inventories. Generally, this study demonstrates the importance of δ2H-CH4 observations for methane source apportionment in regions with a mix of thermogenic and biogenic sources and, especially in our case, where the δ13C signature of the coal mine gas has a large variability.