Geostatic stress field procedure is the first and the most important step for the numerical simulation of geotechnical engineering, which greatly influences the simulation results. Traditional methods often fail when the model is complex. In this paper, based on finite element method (FEM) software ABAQUS, failure reasons of four commonly used methods for the geostatic stress field are studied. According to the analysis results, a new set of methods, which can provide reasonable displacement and stress field results under complex conditions, is proposed. The proposed methods follow the principle that the stress of different materials should be obtained separately to avoid stress distortion. Then, the accuracy and applicability of the proposed method are verified through a comparison study and a specific application. This study provides a theoretical basis for the method of geostatic stress field procedure under complex condition and can serve as a reference for relevant studies.
Geological materials have randomness in nature. Statistical analysis can help revealing the variation pattern of the material parameters and the reliability of the slope. In this paper, the probability distribution and variability of shear strength parameters of typical Q2 and Q3 loess in Northwest China were statistically analysed using the collected geological survey data in Yan`an, Shaanxi Province. Resulting probability properties were applied to the reliability analysis for the natural and fill slope in loess area using the Monte Carlo Method. Finally, an optimization analysis was carried out for the fill slope in the background engineering project. Research results show that normal distribution and lognormal distribution can be used to describe the statistical properties of c and φ of Q2 and Q3 loess. Variance of c is large while the variability of φ is relatively small. The influence of the variability of φ on the reliability index of loess natural slope is generally larger than that of c. On the contrary, influence of the variability of c on the reliability index of the fill slope is generally greater than that of φ, which is related to the structural and uniformity of the soil. Finally, relation between slope height and minimum gradient coefficient is linear when the failure probability of fill slope is less than 10%. Results in this study can be used as a reference for the slope design and construction for the cut and fill engineering in loess area.