Austin Kerr

Austin Kerr

Auto-generated profile, based on publicly available information

Austin Kerr

Department of Electrical and Computer Engineering, Brigham Young University, Provo, UT, USA

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2020 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
JRJace Rozsa
Jace Rozsa
YSYixin Song
Yixin Song
DWDevon Webb
Devon Webb
NDNaomi Debaene
Naomi Debaene
AKAustin Kerr
Austin Kerr
AHAaron Hawkins
Aaron Hawkins
We present a novel and thorough simulation technique to understand image charge generated from charged particles on a printed-circuit-board detector. We also describe a custom differential amplifier to exploit the near-differential input to improve the signal-to-noise-ratio of the measured image charge. The simulation technique analyzes how different parameters such as the position, velocity, and charge magnitude of a particle affect the image charge and the amplifier output. It also enables the designer to directly import signals into circuit simulation software to analyze the full signal conversion process from the image charge to the amplifier output. A novel measurement setup using a Venturi vacuum system injects single charged particles (with diameters in the 100 s of microns range) through a PCB detector containing patterned electrodes to verify our simulation technique and amplifier performance. The measured differential amplifier presented here exhibits a gain of 7.96 µV/e− and a single-pass noise floor of 1030 e−, which is about 13× lower than that of the referenced commercial amplifier. The amplifier also has the capability to reach a single-pass noise floor lower than 140 e−, which has been shown in Cadence simulation.

15 April 2021 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
JRJace Rozsa
Jace Rozsa
YSYixin Song
Yixin Song
AKAustin Kerr
Austin Kerr
NDNaomi Debaene
Naomi Debaene
DADaniel Austin
Daniel Austin
AHAaron Hawkins
Aaron Hawkins
In image charge sensing applications, a tradeoff exists between minimizing detector capacitance for improved amplifier noise performance and adding repeated sensing stages for noise improvement through averaging of repeated signals. In order to understand this tradeoff, the link between image charge detector geometry and capacitance is studied through finite element analysis. This knowledge is then used to present a novel method for determining the relevant detector parameters such that the system noise performance for a given amplifier is optimized. This method is independent of specific amplifier parameters. We find that the optimum noise performance does not lie in simply arbitrarily increasing the number of sensing stages, but depends on the amount of parasitic input capacitance to the amplifier. The greater the parasitic capacitance, the greater the number of stages for the optimum detector. The optimum number of stages is also highly dependent on the detector geometry.