19 February 2018 in IEEE Access
This paper presents a novel approach to achieve a very high level of isolation between the two ports of a compact antenna system for communication and radar applications. Orthogonal polarization and a special symmetric arrangement of two-element arrays of transmitter and receiver antennas are used to achieve high isolation levels. Identical rectangular patch antennas are designed for operation at 6 GHz, and are arranged in a square grid configuration with 90° rotational symmetry in this design. A pair of transmitters and a pair of receivers are fed perfectly out of phase with 180° couplers. The entire system is simulated and fabricated. We measure the prototype antenna's isolation, and use the absolute gain measurement technique and standard far field antenna pattern measurement technique to characterize it's realized gain and radiation pattern. It is found that exploiting symmetry in this manner leads to isolation of 63.7 dB. This indicates that carefully designed and constructed systems could reasonably exhibit isolation on the order of 70 dB or more using this method.
10 June 2021 in IEEE Transactions on Terahertz Science and Technology
An antenna system is proposed that uses a novel polarization-independent spatial power divider to align the beams from two orthogonally oriented dual-polarized feeds. This antenna system uses a common aperture for transmitting and receiving and provides high port isolation while maintaining compatibility with fully polarimetric radar. Unlike conventional two antenna radar systems, a radar using this antenna does not suffer from the parallax problem. The spatial power divider is designed using an all-dielectric metasurface approach and is fabricated on a silicon wafer using standard micromachining technology. The measured device exhibits at most 0.9 dB of difference between the reflection and transmission for both transverse electric and transverse magnetic incident waves at 45° incidence, over a band from 221 to 250 GHz. Conical horns are fabricated as feeds and together with the spatial power divider, a focusing lens, and microwave absorbers, are assembled in a three-dimensional-printed housing to complete the antenna system. Its measured gain is approximately 39 dB for each port and polarization, and isolation between ports is at least 40 dB for all polarization combinations over the band of interest.
24 June 2024 in IEEE Transactions on Radar Systems
This paper presents a fully polarimetric instrumentation radar designed for conducting phenomenological studies in support of autonomous vehicle research at W-band frequencies. The compact radar utilizes a unique single-antenna system with a narrow beamwidth of 1.1° (two-way) and better than 45 dB isolation between the transmit and receive signal paths. It employs the frequency-modulated continuous-wave (FMCW) modulation scheme and operates over a maximum bandwidth of 5.5 GHz centered around 79.25 GHz. The radar benefits from a low phase noise level of -86 dBc/Hz at 10 kHz offset and its receiver channels have an effective noise figure value of 2.7 dB. The calibrated radar can be used to accurately measure the polarimetric response of both point and distributed targets. It can also generate high-resolution range-velocity maps of moving targets in a given traffic scene. The radar was used to characterize the polarimetric response of slow-moving targets, such as pedestrians and bicycles. The statistics of the radar cross-sections of these targets were computed, and unique features observed in the range-velocity maps of these targets were revealed.
4 December 2023 in IEEE Transactions on Antennas and Propagation
This paper presents a design for a very low-profile passive reflector device, which presents a large radar cross-section to forward looking automotive radar. With a total height of less than 0.25 mm, the reflector can be embedded in the paint of road markings, enabling the markings to be detected and identified with radar. This will allow radar to supplement several advanced driver assistance systems currently delegated only to camera sensors, and to improve reliability in poor-visibility and inclement weather conditions. The proposed reflector is designed for operation at the 77 GHz automotive radar band. Fabricated prototypes exhibit measured radar cross-sections of about -13 dBsm, which is large enough to provide more than 20 dB of signal to background for typical underlying asphalt surfaces. It is also demonstrated that spatial patterns of several reflectors can be resolved by radar and used to encode different markings. Finally, with the goal of advising future development, a study of the effects of dielectric materials and water on reflector performance is conducted.
26 July 2023 in IEEE Transactions on Antennas and Propagation
This article describes the design of a planar spatial power divider structure, which splits the energy of a wave incident at 45 degrees to its surface into a transmitted component and an orthogonally directed reflected component. The reflection and transmission coefficients for both TE and TM incident waves are designed to be approximately equal, hence the power divider (combiner) is polarization-independent. The power divider is designed using a combination of all-dielectric metamaterial techniques and concepts of miniaturized-element frequency selective surfaces. The design is facilitated by a circuit modeling approach supplemented with full wave electromagnetic simulations in HFSS. It is fabricated on a silicon wafer using standard microfabrication technology. The measured device exhibits at most 0.9 dB of difference between reflection and transmission for both polarizations over a band from 76 GHz to 84 GHz. This spatial power divider has been integrated into the design of a common-aperture transceiver antenna system in a fully polarimetric E-Band radar.
22 May 2024 in IEEE Transactions on Geoscience and Remote Sensing
This paper reports on polarimetric radar backscatter responses of different types of surfaces at high incidence angles (80° - 89°) at J-band frequencies (221-231 GHz). This study is motivated by the desire to understand the radar phenomenology of target scenes for the next-generation automotive radars. Measured data were collected for paved and unpaved surfaces under different conditions (dry, wet, ice- and snow-covered). At these frequencies, dry road surfaces are electrically rough and sizes of the subsurface aggregates are comparable to the signal wavelength giving rise to significant surface and volume scattering. The measured backscattering coefficients of all surfaces exhibit over 30 dB dynamic range across all data sets and significant depolarization (between -12 dB and -4 dB). For paved surfaces, the dynamic range narrows to 16 dB and the depolarization ranges between -9 dB and -4 dB. The data represent the first reported observations of radar response of surfaces at high incidence angles at J-band frequencies. They demonstrate the radar’s potential for discriminating between different types of road surfaces needed for improved safety of driverless cars. Also, based on the measured data, a semi-empirical model for the backscattering coefficients of the paved surfaces at high incidence angles is presented.