16 February 2022 in Regenerative Biomaterials
Porous architecture in bone substitutes, notably the interconnectivity of pores, is a critical factor for bone ingrowth. However, controlling the pore interconnectivity while maintaining the microarchitecture has not yet been achieved using conventional methods, such as sintering. Herein, we fabricated a porous block using the crystal growth of calcium sulfate dihydrate, and controlled the pore interconnectivity by limiting the region of crystal growth. The calcium sulfate dihydrate blocks were transformed to bone apatite, carbonate apatite (CO3Ap) through dissolution–precipitation reactions. Thus, CO3Ap blocks with 15% and 30% interconnected pore volumes were obtained while maintaining the microarchitecture: they were designated as CO3Ap-15 and CO3Ap-30, respectively. At 4 weeks after implantation in a rabbit femur defect, new bone formed throughout CO3Ap-30, whereas little bone was formed in the center region of CO3Ap-15. At 12 weeks after implantation, a large portion of CO3Ap-30 was replaced with new bone and the boundary with the host bone became blurred. In contrast, CO3Ap-15 remained in the defect and the boundary with the host bone was still clear. Thus, the interconnected pores promote bone ingrowth, followed by replacement of the material with new bone. These findings provide a useful guide for designing bone substitutes for rapid bone regeneration.
1 July 2021 in Ceramics International
26 May 2025 in Materials Today Communications
24 December 2021 in Journal of Southwest Jiaotong University
This study aims to fabricate composite a scaffold using a mixture of chitosan-gelatin and limestone-extracted βTCP for better antibacterial properties. Limestone is abundantly available in nature and can provide calcium in the production of calcium phosphate (CaP) materials. However, the elemental impurities present in limestone-extracted βTCP may affect the properties of the CaP-fabricated scaffolds. βTCP powder could be used to fabricate bone scaffold using calcination and wet precipitation method. For example, the preparation of βTCP powder involved the transformation of calcium carbonate in limestone to calcium hydroxide, followed by a reaction with phosphoric acid and sintering treatment to form βTCP. In order to fabricate the scaffold, chitosan was first dissolved in acetic acid and then mixed with a gelatin-in-water solution, followed by adding βTCP powder (limestone-extracted βTCP and commercial βTCP). Then, the mixture was placed in a mold and freeze-dried. Our method improved the antibacterial activity of chitosan–gelatin–βTCP compared to the chitosan–gelatin scaffold. Limestone-extracted βTCP also exhibited higher inhibitory action against bacteria than commercial βTCP. This method's effectiveness evaluation was confirmed by the measurement of X-ray fluorescence analysis, which showed that βTCP scaffolds had more antibacterial elements than the chitosan–gelatin scaffold. These new research results contribute to enhanced antibacterial properties of the material due to elemental impurities in βTCP, especially the limestone-extracted βTCP. However, further evaluation on controlling βTCP impurities is essential for better outcomes in clinical applications.
29 July 2026 in Surfaces and Interfaces
7 July 2026 in Materials Chemistry and Physics