With the growing demand for solutions to prevent and resolve faults in gas-insulated substations that affect the operation of the electrical system, a fault simulation laboratory for gas-insulated substations was developed to develop solutions for monitoring and locating these faults. The laboratory is composed of instruments for a fault location system based on traveling wave theory. The laboratory also has computational programs for fault simulation control and signal acquisition, in addition to having tools to analyze the data. The results were obtained through tests carried out that confirmed the laboratory's ability to simulate the operation of faults in gas-insulated substations, which allowed demonstrating the capacity of the fault location system using the theory of traveling waves.
1 January 2024 in Brazilian Archives of Biology and Technology
Surge arresters are at the forefront of protection against voltage surges. The loss of the protective effect of surge arresters imposes accidents and unplanned shutdowns on the power system. It directly affects the interruption of power supplies and imposes fines on service providers. Monitoring and diagnostics in the lightning rod field require studies and work that present the degradation behaviour of surge arresters to help develop and improve existing techniques. This paper presents the development of a laboratory with a low-energy, mobile current waveform impulse generator. It allows for conducting aging tests by applying discharges to low-voltage zinc oxide surge arresters used in the energy distribution sector. Samples of surge arresters were subjected to the discharges produced by the developed generator, and they exhibited degradation, thus showing asymmetry between the positive and negative half-cycles of leakage current.
1 January 2023 in Brazilian Archives of Biology and Technology
Shielded substations with SF6 gas insulation (GIS) play a critical role in supplying power to urban areas, and it is crucial to quickly identify and isolate faults to restore system operation and meet supply demands. However, locating faults in such substations can involve extensive and time-consuming procedures, such as opening and closing hermetically sealed compartments containing SF6. This paper presents the development of an acoustic test bench that accurately replicates the dynamic characteristics of SF6 shielded substations. By utilizing the traveling wave technique, partial discharges occurring in high-voltage insulation can be detected and precisely located. The method employs various techniques, including the analysis of the arrival time of traveling waves at different points within the substation and triangulation methods. The use of traveling waves in partial discharge detection offers several advantages, such as precise fault location and non-interference with normal substation operations. Additionally, acoustic methods are highly sensitive to other sources of partial discharges, such as moving particles and fluctuating potential discharges. The results demonstrate that the combination of the acoustic test bench and the disturbance localization technique presents an innovative approach to fault location studies in GIS. The acoustic test bench enables controlled simulation of failure conditions, providing accurate data on the acoustic behavior of substations. Through the disturbance location technique, these data can be analyzed and interpreted to pinpoint the exact fault location. This integrated approach enhances the efficiency of the troubleshooting process and reduces the time required to repair GIS.