25 June 2026 in ACS Omega
The recovery of rare earth elements (REEs) from REE-bearing heavy mineral tailings of the Manisa–Sart (Türkiye) placer depositwith an REE-bearing phase consistent with a monazite-group phosphate host, supported by SEM–EDS microanalysis and bulk geochemical evidencewas investigated via an integrated alkali roasting–reductive acid leaching route. The effects of roasting temperature, NaOH stoichiometry, acid type and concentration, reducing agent addition, and the heating method (conventional vs microwave) on REE extraction efficiency were systematically evaluated. Roasting at 600 °C with a 1:1.5 ore-to-NaOH ratio (w/w) provided the most effective structural activation of the REE-bearing matrix, while 4 M hydrochloric acid was identified as the most effective leaching medium; sulfuric acid yielded substantially lower recoveries due to double-sulfate precipitation. The addition of hydrogen peroxide (H2O2) enhanced cerium extraction approximately 4-fold by reductively converting insoluble Ce(IV) oxide to soluble Ce(III) species. Under optimized conditions (4 M HCl + H2O2, 90 °C, 120 min), neodymium (Nd) and cerium (Ce) extraction efficiencies reached 90.7% and 50.0%, respectively. Dissolution kinetics were analyzed using the Shrinking Core Model (SCM) over a temperature range of 60–90 °C. Both the surface chemical reaction and product layer diffusion control models provided statistically comparable fits (R 2 ≈ 0.944–0.958), and Arrhenius analysis yielded apparent activation energies of 25.79 and 42.95 kJ/mol, respectively, indicating a surface reaction-dominant mixed-control dissolution mechanism. Microwave-assisted roasting (30 min) achieved a Nd extraction of 80.1%, exceeding conventional furnace roasting (2 h) by 5.3 percentage points. This improvement is consistent with an enhanced structural activation under microwave-assisted heating. Titanium dissolution was limited to 31.5% under all conditions, suggesting a natural process selectivity against titanium under the investigated conditions. These findings provide a mechanistic framework and establish energy-conscious operational parameters for the recovery of REEs from secondary placer resources.
16 September 2022 in Mühendis ve Makina
Ülkemiz, demir-çelik endüstrisi başta olmak üzere, metal hammadde ve uç ürünlerinin üretimi açısından dünya piyasasında büyük bir öneme sahiptir. Verimli ve yüksek kaliteye sahip bir üretim sürecinin gerçekleştirilebilmesi için malzemenin, tüm üretim süreci boyunca Karbon (C) ve Kükürt (S) konsantrasyonlarının sürekli izlenmesi gerekmektedir. Söz konusu ürünlerin pazarlanması aşamasında da, malzeme niteliklerinin uygunluk değerlendirme kuruluşları tarafından raporlanması gerekmektedir. Bu aşamada ürünlerin kalite kontrol testlerinde, ölçüm sonuçlarının doğruluğunun arttırılması ve güvenilirliğinin sağlanması beklenmektedir. Bu amaçla, uygunluk değerlendirme kuruluşları tarafından gerçekleştirilen testlerde öncelikle uygulanan analiz metodunun doğrulanması ve geçerli kılınması sağlanmalıdır. Ancak bu konuda ilgili uluslararası kılavuzlarda açıklanan prosedürlerin dışında kalan farklı uygulamaların olduğu gözlenmektedir. Bu çalışmada, mevcut en iyi tekniklere örnek olarak, metal ve alaşımlarda toplam karbon (C) ve toplam kükürt (S) analizleri için " TS EN ISO/IEC 17025 Deney ve Kalibrasyon Laboratuvarlarının Yeterliliği İçin Genel Gereklilikler " standardında açıklanan prosedürler izlenerek yöntem doğrulama ve belirsizlik tahmini çalışmaları yapılmıştır.
1 January 2026 in Journal of Chemistry
Platinum nanoparticles (PtNPs) were synthesized via both ethanol‐based chemical reduction and plant‐mediated green routes using Achillea millefolium and Echinacea purpurea extracts as reducing and stabilizing agents. In the chemical route, H 2 PtCl 6 ·xH 2 O was reduced in ethanol in the presence of polyvinylpyrrolidone with different molecular weights to control nanoparticle stabilization and growth. The synthesized PtNPs were characterized by UV–vis spectroscopy, Fourier transform infrared (FTIR) spectroscopy, XX‐ray diffraction (XRD), scanning electron microscopy (SEM), and dynamic light scattering (DLS). Structural analysis revealed face‐centered‐cubic Pt 0 formation in all samples, while green synthesis produced smaller crystallite sizes with increased lattice strain compared to chemically synthesized nanoparticles. Catalytic performance was evaluated via calcium peroxide decomposition in phosphate‐buffered saline, serving as a model oxygen generation system. Among all samples, A. millefolium –derived PtNPs exhibited the highest catalytic activity, attributed to the combined effects of smaller crystallite size, higher lattice distortion, and surface functionalization arising from the plant‐mediated synthesis environment. These findings demonstrate a clear structure–property–activity relationship between synthesis route, surface chemistry, and catalytic oxygen evolution, highlighting the potential of plant‐mediated approaches for designing efficient and sustainable platinum‐based nanocatalysts.
1 January 2018 in Dokuz Eylül Üniversitesi Mühendislik Fakültesi Fen ve Mühendislik Dergisi
13 March 2019 in International Journal of Coal Preparation and Utilization
The parameters specify coal including ash, volatile matter, and calorific values have great importance in the use of coal as it is or in other forms. Coal is occluded in typical oxide and sulfide wall rocks. Various amounts of these carbonate, sulfide, oxide, and silicate minerals could result in different analyses outcomes for the coal with similar calorific value. The present study investigates the effect of mineral matter content in the coal on the proximate analysis parameters. The coal mixtures were prepared by the addition of different minerals included in the foot and hanging wall rock to the clean coal. Experimental results were compared with the results obtained from the theoretical models reported in the literature. The detailed chemical analysis and mineral compositions supported by the XRD analyses are presented. The results revealed that the carbonate component in the coal changes the ash content and volatile matter values significantly which directly influence the rank of the coal.
14 June 2026 in Journal of the Iranian Chemical Society