1 November 2002 in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
The performance of chemically amplified photoresists is extremely sensitive to interfacial and surface phenomena, which cause deviations in the pattern profile near an interface. Striking examples include T-topping or closure near the air/resist interface and footing or undercutting near the resist/substrate interface. One focus of our research is to identify mechanisms that cause lithographic patterns to deviate near interfaces. Near edge x-ray absorption fine structure (NEXAFS) is a powerful tool that can be developed and adapted to probe for detailed chemical information near lithographically relevant interfaces. NEXAFS showed that our model resist films exhibited significant surface segregation of the photo acid generator (PAG) at the air interface. The PAG surface mole fraction was 20–70 times greater than the bulk mole fraction and the amount of surface segregation was dependent on the polarity of the polymer. NEXAFS also revealed that the PAG surface fraction was reduced after a postexposure bake. In the absence of delay times between processing steps, the PAG surface enhancement led to a faster deprotection reaction rate near the air interface relative to the bulk. However, when significant postexposure delay times were incorporated into the processing, NEXAFS showed that the surface deprotection reaction was incomplete after postexposure baking. Comparison of carbon K-edge, and oxygen K-edge NEXAFS spectra showed that the incomplete surface reaction was localized at the air interface. While delay effects have previously been linked to deterioration of resist performance, NEXAFS proved to be a valuable tool for providing detailed chemical specificity about the resist surface composition and deprotection kinetics.
22 July 2002 in Applied Physics Letters
High-resolution x-ray reflectivity (XR) and small-angle neutron scattering (SANS) are applied to characterize both the nonuniform depth profile and pore structure of a low-dielectric-constant (low-k) thin film as prepared on a silicon substrate. The XR data show that the density depth profile has a multilayered structure with a dense, nonporous top layer and a less dense, porous bulk layer. A scattering invariant analysis of the SANS data is used to determine the average chord length of the pores, independent of the depth profile. Given the elemental composition of the film, the XR and SANS data are combined to calculate the mass density of the top layer, the porosity of the less dense layer, and the wall density,