Glued Laminated Timber technology allows the construction of wooden structural components bonded with adhesive. This technology enables the creation of large-scale structures, with technological control over the material, and in a competitive industrial system. Focusing on the structural application of wood, the present study assessed the strength of bonded joints with different angles between the fibers of Pinus sp. wood, joined with a two-component polyurethane adhesive based on vegetable oils. The bonded joints were fabricated with angles of 0°, 10°, 20°, 30°, 45°, 60°, 70°, 80°, and 90°, and were evaluated for shear strength under compression and torsion. When regression analysis was performed, shear compression values showed compliance with Hankinson’s equation, with an R2 value close to 0.76. However, shear torsion results yielded R2 values near 0.17. Thus, Hankinson’s equation was unsuitable as an estimator for torsional shear strength values. The specimens showed a different mechanical response to shear when tested in compression compared to those tested in torsion.
The main function of the adhesive is to promote adhesion between materials, as well as provide fluidity and fill in the gaps between joints. Information such as grammage and bonding pressure is fundamental when it comes to the execution of structures in glued laminated wood. In this sense, the objective of this study was to evaluate the shear strength in compression of bonded joints using a one-component polyurethane adhesive with cold curing at three different gram levels, being 150 g.m-2, 200 g.m-2 and 250 g.m-2, with spreading on a single face, applied at two pressure levels, 0.7 MPa, and 1.0 MPa. The apparent density was determined, and with that, four blocks/density groups were obtained, which comprised four repetitions. In addition, the percentage of failure in the specimens after performing the shear test was analyzed. Statistical data analysis was carried out adopting a randomized design in a 2x3 factorial block to analyze the effects of grammage and bonding pressure on wood strength and failure The homogeneity and normality of the data were tested, and later the analysis of variance (ANOVA). The results showed that the joints’ strength was not affected, both for weight and pressure levels. As for the wood failure percentage, the values obtained were low, with averages below 35%.
16 January 2022 in Research, Society and Development
A indústria da construção civil é uma grande consumidora de recursos naturais, gerando muitos resíduos e sendo responsável por grande parte dos impactos ambientais mundiais. O emprego da madeira em estruturas ressurge como um material ambientalmente correto no setor da construção civil e agrícola por ser um material construtivo/estrutural renovável e seu uso de forma permanente contribui com a redução das emissões de carbono na atmosfera. Com isso, o presente estudo objetivou executar e ensaiar pórticos com tirantes, feitos em madeira laminada colada, de modo a avaliar sua aplicação estrutural em aviários. Foram confeccionados quatro pórticos em escala reduzida com tirantes de barras rosqueadas de 3/8”, com vão livre de 1,9 metros e altura de pilar de 1,83 metros. Os materiais utilizados para a confecção dos pórticos foram a madeira de Pinus sp. e adesivo bicomponente à base de óleos vegetais. As estruturas romperam para uma carga média de 1,37 vezes a carga de verificação estabelecida e exibiram deslocamentos próximos a linearidade mesmo para cargas elevadas. Ainda, obteve-se um coeficiente de correlação de 0,95 entre a densidade aparente da madeira dos pórticos com sua resistência. Desta forma, as evidências obtidas indicam que o emprego do tirante nas estruturas promoveu a melhoria do desempenho mecânico quanto à resistência e rigidez.