29 May 2020 in IEEE Open Journal of the Industrial Electronics Society
Z packed U-cell (ZPUC) converter topology is presented in this paper as a new type of multilevel converter topology that can be operated in a single-phase as well as in three-phase configurations while using a single DC source. Since each U-cell includes two switches and one capacitor, in this topology, three U-cells are needed to generate 5 or 7 voltage levels. Moreover, the configuration proposed for the ZPUC is more appropriate for high-power application modular multilevel converters (MMCs) to increase the voltage levels compared to other topologies. Accurate voltage balancing on small-sized auxiliary capacitors is due to an integrated modulation strategy without using additional controllers; additionally, the reduction of total harmonic distortion (THD) in AC currents for higher voltage levels is an advantage of this configuration. A full topology sequence of operation and performance analysis of ZPUC based on the 5-L inverter is investigated in Matlab-Simulink and experimentally validated on a 3 kVA prototype. The obtained results illustrate the good dynamic performance of the proposed topology and the implemented integrated switching pattern voltage balancing.
1 December 2021 in IEEE Open Journal of the Industrial Electronics Society
A new configuration of three-phase Wye Packed U-cells (Y-PUC) with a single DC source is proposed in this paper. In fact, this configuration represents a single DC source modular three-phase PUC converter. The DC source on PUC topology is replaced by a flying capacitor to obtain a suitable submodule. Moreover, the modularity of the Y-PUC configuration makes it an appropriate alternative for MMC applications. Furthermore, the proposed structure is an advantageous configuration for high voltage applications such as high voltage direct current (HVDC) transmission lines with the capability of DC fault handling. All PUC topologies such as PUC5, PUC7, PUC9, PUC15 can be replaced in the modules of this proposed single-phase and three-phase configuration to multiply the load voltage levels for improving the output waveform. Active voltage balancing technique through carrier-based modulation is applied. System modeling and operating sequences are developed. Simulation and experimental results are presented and discussed to validate the performance of the proposed structure.