28 October 2015 in Electronic Materials Letters
26 February 2019 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Proper control of solder heating and melting leads to successful joining of surface mount technology (SMT) devices to the metallization of printed circuit boards (PCBs). When developing new solder alloys for more miniaturized and lower temperature processes, improved process control for the heating and melting during solder reflow can be beneficial. To find an optimized temperature profile efficiently, it is helpful to know the exact onset times of the physical mechanisms of soldering including sintering, melting, and solidification. In particular, to exactly know the time the solder remains in the molten state can help to minimize temperature exposure of sensitive substrates. To this end, we used standard lead-free SAC305 solder and a real time resistance monitoring setup to observe in-process resistance during the soldering of a 0805 type chip resistor to find out exact points in time when the soldering mechanisms occur. Cross-sectioning studies and microscopic observations were performed in parallel to explain three distinct resistance drops observed in the resistance signals. Sintering of solder balls resulted in drop 1, the collapse and melting of all the solder balls resulted in drop 2, and the solidification of solder resulted in drop 3, which actually consisted of two separate drops, one for each solder joint of the chip resistor. The observation of the resistance drop due to solder solidification was achieved because our newly improved setup reduced the signal noise to less than 0.012 milliohm (root mean square value). On average, the solder was in a liquid state for 17.6 min ± 0.18 min (7 samples). The solidification drop was 0.2 milliohm and happened at approximately 200 °C, indicating not more than 28 K of undercooling. Such an accurate measurement of melting and solidification times may prove useful in the future when optimizing reflow temperature profiles for advanced soldering applications, e.g. to minimize the meltingsolidification interval on heat sensitive thin flexible substrates for wearables.
23 April 2015 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Contact resistance measurement configurations for the evaluation of ball bond reliability on thin metallizations are studied. Samples with symmetrical and asymmetrical four-wire probe configurations are analyzed and compared with a calibrated finite-element model. It is found that the measured contact resistance strongly depends on the geometric placement of the probe wires, and the value closest to the true value is obtained from a probe placement that is opposite and away from high-current-density regions on the metallization. Probes should also be placed as close as possible to the contact interface. Sheet resistance components contributed by intermediate thin metallizations are of the same order of magnitude as the unaged reported RC. Therefore, they are considered. Symmetrical current distributions yield a more homogeneous potential drop across the bond interface being probed, but also capture a larger component of metallization sheet resistance. Experimental samples were aged, and the contact resistance increase was measured. The impacts of various probe placements on the sensed RC were studied.
3 March 2009 in Journal of Electronic Materials
3 April 2009 in Journal of Electronic Materials