2 May 2017 in The International Journal of Advanced Manufacturing Technology
10 November 2015 in The International Journal of Advanced Manufacturing Technology
29 October 2018 in Materials Research
MSMurillo Romero da Silva
In this work, theoretical composition design and thermo-mechanical treatments were combined in order to improve the mechanical compatibility of a biomedical β-type titanium alloy. By applying a composition design theory, cold rolling and low temperature aging, a metastable β-type Ti-35Nb-7Zr-5Ta (wt%) alloy with an elastic modulus of 47 GPa and a yield strength of 730 MPa was successfully fabricated. This combination of high yield strength and low elastic modulus resulted in enhanced elastic recoverable strain of 1.7%, which is much higher than that of the conventional metallic biomaterials. The microstructure responsible for the much sought-after mechanical properties was observed to be mainly consisted of a homogeneous distribution of nanometer-sized ω- and α-precipitates in a β-phase matrix obtained via cold rolling plus short-time aging at low temperature, i.e. aging at 673 K for 20 min. These precipitates increase the strength of the material by hindering the motion of dislocations while the β-matrix with relatively low content of β-stabilizers gives rise to the observed low elastic modulus. By extending aging time, a higher strength is reached at the expense of an undesirable increasing in elastic modulus.
29 October 2023 in Advanced Engineering Materials
1 January 2020 in Materials Research
As part of an ongoing process to fully assess the potential for friction stir welding (FSW) to be used in the aerospace industry, an attempt was made to produce double sided FSW joints at traverse speeds equal or higher than 5 mm/s of AA2050-T84 12.7 mm thick plates for high-volume production applications. With an emphasis on weld quality, the local and global mechanical properties were evaluated and correlated with microstructure of the welding area. Sound welds with no volumetric defects were obtained for tool traverse speeds up to 12 mm/s, resulting in yield and ultimate tensile strengths corresponding to 65% and 77% of base material, respectively. The metallurgical and mechanical characterization demonstrate that density of Cu-rich precipitates has a first order effect on micro-hardness variation. In the stir zone the dissolution temperature of this precipitate is achieved and its volume fraction is greatly reduced. The remaining precipitates seems to be partially dissolved and undergone a significant thickening at the welding zones in which the process temperature has not reached the dissolution temperature. Weld fractures after tensile tests were observed to start in the region of hardness minima.
1 October 2014 in Materials Research