This article presents the utilization of the chemical–mechanical polishing (CMP) method to fabricate high-performance N-polar GaN/AlGaN metal–insulator–semiconductor high-electron-mobility transistors (MIS-HEMTs) through layer transfer technology. The nucleation and buffer layers were removed via CMP to attain a pristine N-polar GaN surface with elevated smoothness, featuring a low root-mean-square (RMS) roughness of 0.216 nm. Oxygen, carbon, and chlorine impurity elements content were low after the CMP process, as detected via X-ray photoelectron spectroscopy (XPS). The electrical properties of N-polar HEMTs fabricated via CMP exhibited a sheet resistance (Rsh) of 244.7 Ω/sq, a mobility of 1230 cm2/V·s, and an ns of 2.24 × 1013 cm−2. Compared with a counter device fabricated via inductively coupled plasma (ICP) dry etching, the CMP devices showed an improved output current of 756.1 mA/mm, reduced on-resistance of 6.51 Ω·mm, and a significantly reduced subthreshold slope mainly attributed to the improved surface conditions. Meanwhile, owing to the MIS configuration, the reverse gate leakage current could be reduced to as low as 15 μA/mm. These results highlight the feasibility of the CMP-involved epitaxial layer transfer (ELT) technique to deliver superior N-polar GaN MIS-HEMTs for power electronic applications.
This study has demonstrated AlGaN/GaN metal-insulator-semiconductor high electron mobility transistors (MIS-HEMTs) on Si substrates with a SiNx/SiON composite gate dielectric. The threshold voltage shift in the devices was investigated. The MIS-HEMTs with the SiNx/SiON composite gate dielectric exhibited superior threshold voltage uniformity and small threshold voltage hysteresis than the reference device with SiNx only gate dielectric. The variation of the device threshold voltage was mainly related to trapping process by the interface states, as confirmed by band diagrams of MIS-HEMTs at different gate biases. Based on frequency-dependent capacitance measurements, interface state densities of the devices with the composite and single gate dielectrics were extracted, where the former showed much smaller interface state density. These results indicate that the SiNx/SiON composite gate dielectric can effectively improve the device performance of GaN-based MIS-HEMTs and contribute to the development of high-performance GaN electronic devices.
Oxygen vacancies (Vo) can significantly degrade the electrical properties of indium oxide (In2O3) thin films, thus limiting their application in the field of ultraviolet detection. In this work, the Vo is effectively suppressed by adjusting the Trimethylindium (TMIn) flow rate (fTMIn). In addition, with the reduction of the fTMIn, the background carrier concentration and the roughness of the film decrease gradually. And a smooth In2O3 thin film with roughness of 0.44 nm is obtained when the fTMIn is 5 sccm. The MSM photodetectors (PDs) are constructed based on In2O3 thin films with different fTMIn to investigate the opto-electric characteristics of the films. The dark current of the PDs is significantly reduced by five orders from 100 mA to 0.28 μA with the reduction of the fTMIn from 50 sccm to 5 sccm. In addition, the photo response capacity of PDs is dramatically enhanced. The photo-to-dark current ratio (PDCR) increases from 0 to 2589. Finally, the PD with the fTMIn of 5 sccm possesses a record-high responsivity of 2.53 × 103 AW−1, a high detectivity of 5.43 × 107 Jones and a high EQE of 9383 × 100%. Our work provides an important reference for the fabrication of high-sensitivity UV PDs.
In this work, AlN films were grown using gallium (Ga) as surfactant on 4° off-axis 4H-SiC substrates via microwave plasma chemical vapor deposition (MPCVD). We have found that AlN growth rate can be greatly improved due to the catalytic effect of trimethyl-gallium (TMGa), but AlN crystal structure and composition are not affected. When the proportion of TMGa in gas phase was low, crystal quality of AlN can be improved and three-dimensional growth mode of AlN was enhanced with the increase of Ga source. When the proportion of TMGa in gas phase was high, two-dimensional growth mode of AlN was presented, with the increase of Ga source results in the deterioration of AlN crystal quality. Finally, employing a two-step growth approach, involving the initial growth of Ga-free AlN nucleation layer followed by Ga-assisted AlN growth, high quality of AlN film with flat surface was obtained and the full width at half maximum (FWHM) values of 415 nm AlN (002) and (102) planes were 465 and 597 arcsec.