Dmitri A. Blagov

Dmitri A. Blagov

Auto-generated profile, based on publicly available information

Dmitri A. Blagov

Federal Scientific Agroengineering Center VIM

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 June 2023 in Agrarian science
Verified
Journal Article
Open access
PDF file
SMS. V. Mitrofanov
S. V. Mitrofanov
NON. V. Orlova
N. V. Orlova
DBD. A. Blagov
D. A. Blagov
NPN. S. Panferov
N. S. Panferov
VTVladimir Teterin
Vladimir Teterin
Анализ тенденций развития тукосмесительного оборудования

27 September 2023 in Agrarian science
Verified
Journal Article
Open access
PDF file
IDIgor Mamedyarevich Dovlatov
Igor Mamedyarevich Dovlatov
IKilya Komkov
ilya Komkov
AAA. Yu. Alipichev
A. Yu. Alipichev
DBD. A. Blagov
D. A. Blagov
SYS. S. Yurochka
S. S. Yurochka
Technical solutions to ensure the necessary values of parameters are studied. Considered scientific research on the subject of control of microclimatic parameters. Identified the main components of the living conditions, ways to maintain their regulated values in the room. The methods of influencing them are considered. Developed a simplified model of the farm in the software package SketchUp 2020, simulations were carried out in the software package SolidWorks 2020. General parameters set for the calculation: heat emitted by the cows — 1000 W; amount of carbon dioxide — 4% in the exhaled air; wind speed at the window inlet — 2 m/s, humidity — 70%, temperature — 25 ºC. The materials used in the study are displayed. Parametric models for the nature and velocity of air flows are presented. The main ways of regulating the indicators of interest are analyzed. The most suitable solutions for modernization and re-equipment of production facilities to improve the microclimate in the cattle housing are identified and described. The functional and structural scheme of technical solutions to ensure the parameters of the microclimate is formed. The technological map of conceptual proposals is made and displayed. On their basis, the main solutions for modernization of farms are defined: natural ventilation, axial and suspended fans, light ridge, nozzles, lifting curtains, artificial lighting.

30 July 2023 in Agrarian science
Verified
Journal Article
Open access
PDF file
IDIgor Mamedyarevich Dovlatov
Igor Mamedyarevich Dovlatov
SYS. S. Yurochka
S. S. Yurochka
DBD. A. Blagov
D. A. Blagov
The article presents studies on the concentration of harmful gases and the movement of air flows in the livestock room. Due to the fact that hydrogen sulfide is extremely volatile, it is well susceptible to removal by ventilation, because of this, maximum peaks of its concentration can be observed in the exhaust area. For a height of 0.5 m, it was 1.66 mg/m3, for 1.5 m — 1.92 mg/m³, and at a height of 2 m, the concentration reached 1.8 mg/m3. The largest amount of carbon dioxide is localized in the feed passage. This is due to the fact that animals most of the time are located in the direction in his direction, and since cattle are the main source of carbon dioxide, since a larger amount is released during respiration, then the main localization of the gas will be directly in the feed passage. In the area of ventilation, CO2 concentrations are equal to 1054 ppm, and in the area without ventilation — 1178 ppm. The maximum peaks of ammonia localization have been established, most of them are located in the area of the room in which the ventilation system is located. For a height of 0.5 m, it was 45.4 mg/m3, for 1.5 m — 43.6 mg/m3, and at a height of 2 m, the concentration reached 44.4 mg/m3. Ammonia concentrations equal to 27.3 mg/m3, 24.8 mg/m3 and 28.6 mg/m3, respectively, were detected at the aft passage, which is closer to the hood, at heights of 0.5 m, 1.5 m and 2 m. Above the feed table, which is located in the part of the cowshed without ventilation, indicators equal to 41.2 mg/m3, 48.7 mg/m3, 22 mg/m3 were found for a height of 0.5 m, 1.5 m and 2 m, respectively. Studies have shown that the peak values of gases are in the area of the cowshed, in which the ventilation system is located. It also depends on the properties of gases (lighter will reach ventilation faster).

11 November 2021
Verified
Book Chapter
Closed access
PDF file
VTVladimir Teterin
Vladimir Teterin
MKMikhail Kostenko
Mikhail Kostenko
OTOlga Teterina
Olga Teterina
DBDmitry Blagov
Dmitry Blagov
SMSergey Mitrofanov
Sergey Mitrofanov

25 May 2024 in Agrarian science
Verified
Journal Article
Open access
PDF file
IMI. V. Mironova
I. V. Mironova
ELE. H. Latypova
E. H. Latypova
Evgeniy Alexandrovich NikitinEvgeniy Alexandrovich Nikitin
Evgeniy Alexandrovich Nikitin
DBD. A. Blagov
D. A. Blagov
Relevance. When forming a diet for feeding animals that are kept in modern livestock complexes, the farmer pursues an exceptionally rational approach in terms of livestock productivity and the period of productive existence of animals. First of all, the provision of these indicators forms the quality of animal feeding, expressed in the total nutritional value of the diet and the quality of mixing the components that make up its composition.Methods. The updating of the direction of scientific research was carried out on the basis of a preliminary literary review of modern publications in the international journals Journal of dairy science, Robotics and autonomous systems and Agriculture. In addition, the functionality of modern analytical equipment from world manufacturers used in agriculture was analyzed. The technical solutions of the exhibits of industry exhibitions, as well as the accompanying documentation, are considered. The existing methods for determining the homogeneity of feed mixtures for farm animals have been studied, advantages and disadvantages have been identified.Results . The existing methods for estimating the homogeneity of feed mixtures are considered. A new concept has been proposed for constructing a system for determining the homogeneity of feed mixtures by optical methods, which is based on express measurement of the optical properties of feed mixture components on the surface of a conveyor belt or mixing unit, the use of which will allow you to manage the temporary modes of mixing feeds and assess the serviceability of the machines and units used.

5 October 2021
Verified
Book Chapter
Closed access
PDF file
VTVladimir Teterin
Vladimir Teterin
MKMikhail Kostenko
Mikhail Kostenko
DBDmitry Blagov
Dmitry Blagov
SMSergey Mitrofanov
Sergey Mitrofanov
OTOlga Teterina
Olga Teterina