13 October 2023 in Scientific Reports
Plain bearings, renowned for their versatility and simplicity, are extensively utilized in engineering design across various industries involving moving parts. Lubrication is vital to the functioning of these bearings, yet their usage is inhibited under dynamic load conditions, or at elevated or reduced temperatures due to this dependency on lubrication. This study introduces an innovative method to significantly mitigate friction and wear in plain bearings operating without lubrication. The plain bearings were constructed from steel–bronze pairs, where the steel shafts were alloyed with bismuth oxide via short-pulse laser treatment. MnO2 was utilized as a carrier to incorporate the bismuth oxide into the surface layers of the steel. Insights from transmission electron microscopy and X-ray photoelectron spectroscopy revealed a highly non-equilibrium state of matter, unattainable through conventional engineering methods. The tribological performance of the modified steel disks was assessed via a block-on-ring sliding test, demonstrating superior wear and friction performance without lubrication, as well as an ultra-low coefficient of friction. Remarkably, the modified friction pairs remained functional after 200 km of linear sliding at a load of 250 N (12.5 MPa) and a sliding speed of 9 m/s. To substantiate the technique’s viability, we tested the performance of an internal combustion engine turbocharger fitted with a modified steel shaft. The turbocharger’s performance validated the long-term effectiveness of the steel–bronze coupling operating without lubrication at 75,000 rpm. The simplicity and resilience of this technique for modifying steel–bronze pairs offer a ground-breaking and promising approach for a wide range of applications.
1 May 2020 in Surface and Coatings Technology
1 February 2020 in Journal of Crystal Growth
11 October 2013 in Physics of Metals and Metallography
Presented here is a brief review of research of an authors’ collective dealing with laser treatment of materials, sintering metallic powders, and multiscale simulation. A theoretical analysis of the processes of structure formation upon the rapid laser synthesis of composite coatings has been performed. The experimentally obtained structural and phase characteristics of the sintered layers have been explained based on an analytical and numerical simulation of the dynamics of thermal fields in the zone of treatment, processes of melting, and subsequent solidification of porous materials. Upon rapid sintering and solidification, the effect of impurity trapping has been taken into account, which determines the chemical composition of the powders under nonequilibrium conditions of their formation. It has been shown that rapid laser treatment retains the composite structure of the powder layer due to the high rates of local heating/cooling and high rate of solidification comparable with the rate of diffusion of chemical components. The results obtained are applicable in the development of a wide class of functional-gradient composite materials.
1 November 2019 in Journal of Crystal Growth