Yanran Xie

Yanran Xie

Auto-generated profile, based on publicly available information

Yanran Xie

Department of Engineering Physics, McMaster University, Hamilton, ON, Canada

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 July 2021 in Optical Materials Express
Verified
Journal Article
Open access
PDF file
YXYanran Xie
Yanran Xie
HFHenry C. Frankis
Henry C. Frankis
JBJonathan D. B. Bradley
Jonathan D. B. Bradley
AKAndrew P. Knights
Andrew P. Knights
We report a resonance trimming technique, applicable to waveguides employing an SiO2 cladding. The SiO2 is deposited by a room temperature sputtering process. Resonance shifts of micro-ring resonators of 4.4 nm were achieved with furnace annealing, whereas a resonance shift of 1.4 nm was achieved using integrated micro-heaters. For our device layout, with 30 μm ring separation, the thermal cross-talk is negligible, and isolated trimming of each micro-ring is achieved. Three, single-channel ring filters on the same substrate were aligned to the same wavelength within a 20 pm precision. The stability of trimmed micro-rings was assessed following extended storage in atmospheric ambient. For a ring shifted by 4.4 nm using furnace annealing, relaxation of 540 pm is observed, while for a ring shifted by 1.4 nm using integrated heaters, the relaxation is 270 pm.

30 September 2022 in Photonics Research
Verified
Journal Article
Closed access
RDRanjan Das
Ranjan Das
YXYanran Xie
Yanran Xie
HFHenry Frankis
Henry Frankis
KCKeru Chen
Keru Chen
HRHermann Rufenacht
Hermann Rufenacht
AKAndrew P. Knights
Andrew P. Knights
A compact time delay unit is fundamental to integrated photonic circuits with applications in, for example, optical beam-forming networks, photonic equalization, and finite and infinite impulse response optical filtering. In this paper, we report a novel gain-enabled delay readout system using a tunable optical carrier, low-frequency RF signal and CMOS-compatible photodetectors, suitable for silicon photonic integration. The characterization method relies on direct phase measurement of an input RF signal and thereafter extraction of the delay profile. Both integrated silicon and germanium photodetectors coupled with low-bandwidth electronics are used to characterize a microring resonator-based, true-time delay unit under distinct ring–bus coupling formats. The detectors, used in both linear and avalanche mode, are shown to be successful as optical-to-electrical converters and RF amplifiers without introducing significant phase distortion. For a Si–Ge separate-absorption-charge-multiplication avalanche detector, an RF amplification of 10 dB is observed relative to a Ge PIN linear detector. An all-silicon defect-mediated avalanche photodetector is shown to have a 3 dB RF amplification compared to the same PIN detector. All ring delay measurement results are validated by full-wave simulation. Additionally, the impact of photodetector biasing and system linearity is analyzed.

2 August 2022 in Optics Express
Verified
Journal Article
Closed access
HFHenry Frankis
Henry Frankis
YXYanran Xie
Yanran Xie
RDRanjan Das
Ranjan Das
KCKeru Chen
Keru Chen
HRHermann Rufenacht
Hermann Rufenacht
AKAndrew P. Knights
Andrew P. Knights
Recent advances in silicon photonic components operating in the thulium-doped fiber amplifier (TDFA) wavelength regime around 2-µm have shown that these wavelengths hold great promise for on-chip photonic systems. Here we present our work on characterizing a Mach-Zehnder interferometer coupled silicon photonic ring resonator operating in the TDFA window for optical time delay applications. We describe the optical transmission and variable time delay properties of the resonator, including a detailed characterization and comparison of the directional coupler and Mach-Zehnder interferometer base components at both 1930 and 1550 nm wavelengths. The results show tuning of a ring from a 190-ps peak time delay at a resonant extinction ratio of 5.1-dB to a 560-ps peak time delay at an extinction ratio of 11.0-dB, in good agreement with optical models of the device. These results demonstrate significant promise towards the future application of TDFA band devices in optical time delay systems.

8 January 2024 in Optics Express
Verified
Journal Article
Closed access
YGYuxuan Gao
Yuxuan Gao
RDRanjan Das
Ranjan Das
YXYanran Xie
Yanran Xie
FGFeng Guo
Feng Guo
PMPeter Mascher
Peter Mascher
AKAndrew P. Knights
Andrew P. Knights
In this article, we report a Si/Ge waveguide phototransistor with high responsivity and low dark current under low bias voltages, due to an engineered electric field distribution. The photodetector consists of n-i-p-i-n doping regions and shows a responsivity of 606 A/W at 1 V bias, and 1032 A/W at 2.8V bias with an input optical power of −50 dBm, and dark current of 4 µA and 42 µA respectively. This is achieved by placing two p+-doped regions in the silicon slab region beneath the Ge epitaxial layer. A measured small signal −3 dB bandwidth of 1.5 GHz with a −80 dBc/Hz phase noise response at 1 KHz frequency offset were demonstrated experimentally.

5 September 2023 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
DHDavid H. Hagan
David H. Hagan
YXYanran Xie
Yanran Xie
RDRanjan Das
Ranjan Das
AKAazar S. Kashi
Aazar S. Kashi
JCJohn C. Cartledge
John C. Cartledge
AKAndrew P. Knights
Andrew P. Knights
Monolithic silicon sub-bandgap avalanche photodetectors are fabricated using the introduction of lattice defects to silicon waveguides through silicon ion implantation and annealing. The devices are characterized using light at a wavelength of 1550 nm. Through control of implantation dose we create a low-absorption device with 0.4 dB (5.4 dB/cm) excess optical absorption, and a high-absorption device with 3.2 dB (42 dB/cm) excess optical absorption. The low-frequency unity-gain bias point, M = 1, is approximately 12 V for both devices. Increasing reverse bias results in electrical gain such that M = 35 at 32 V for the high-absorption device, with associated responsivity of 13 A/W for coupled optical power ranging from −20 dBm to −5 dBm. The electrical bandwidth of this device peaks at 10 GHz for M = 14 and decreases to 6 GHz for M = 35. The RC limited bandwidth of an unimplanted, control device is measured to be 26 GHz. The gain-bandwidth product of the high-absorption device is 230 GHz. Measurement of the excess noise factor provides an effective k -value of 0.1, consistent with the gain-bandwidth product. Primary carriers in the avalanche process are predominatly electrons, with a carrier ionization threshold of ∼ 0.6eV, indicating for the first time in this device type that both the light detection and avalanche process are mediated by the deep-levels.

11 February 2026 in TechRxiv
Verified
Preprint
Open access
YXYanran Xie
Yanran Xie
RDRanjan Das
Ranjan Das
AKAndrew P. Knights
Andrew P. Knights
In this work, we characterize the noise associated with the operation of all-silicon avalanche photodetectors integrated on a silicon-on-insulator platform, designed to operate at 1550 nm. The silicon waveguide photodetectors are sensitized to sub-bandgap light through inert ion implantation and lowtemperature annealing. The devices are subsequently operated in the avalanche mode. The excess noise factor is correlated with the mid-gap defect concentration, with an associated saturated value k = 0.1, where k is defined as the ratio of hole to electron impact ionization coefficient. In addition, the noise equivalent power (NEP) is measured to be 30 pW/ √ Hz, achieved in the device with lowest ion implantation dose.