20 May 2019 in IEEE Journal of Selected Topics in Quantum Electronics
A successful design, fabrication and test of silicon photonic circuits requires design tools, process design kits (PDKs), foundries for fabrication, and test facilities. This paper describes the complete design flow of photonic circuits using rapid-prototyping multiproject wafer foundry processes available in the SiEPIC program. The focus of this paper is on rapid prototyping based on electron beam lithography as an alternative and complementary to what is available via deep-UV lithography-based foundries. We describe in detail the PDK and the use of open-source and commercial tools for the design of optical filters, sensors, neuromorphic photonic processors, optical switches, and discuss test and packaging approaches for these designs. We demonstrate that a “germanium less” process can be used to build small systems featuring photoconductive detectors, electronics, and phase shifters.
19 December 2016 in Journal of Optics
We report the measurement of optical loss in submicron silicon-on-insulator waveguides at a wavelength of 2.02 μ m for the fundamental TE mode. Devices were fabricated at IMEC and at A ⋆ STAR's Institute of Microelectronics (IME) and thus these measurements are applicable to studies which require fabrication using standard foundry technology. Propagation loss for strip and rib waveguides of 3.3 ± 0.5 and 1.9 ± 0.2 dB cm −1 were measured. Waveguide bending loss in strip and rib waveguides was measured to be 0.36 and 0.68 dB per 90° bend for a radius of 3 μ m. Doped waveguide loss in rib waveguides was measured for both n -type and p -type species at two doping densities for each doping type. Measured results from propagation, bending, and free-carrier loss were found to be in good agreement with analytical or numerical models. Loss due to lattice defects introduced by ion-implantation is found to be underestimated by a previously proposed empirical model. The thermal annealing of the lattice defects is consistent with removal of the silicon divacancy.
28 August 2019 in IEEE Journal of Selected Topics in Quantum Electronics
Photo-detection in the wavelength range 1850 to 2000 nm using evanescently coupled germanium detectors grown on silicon waveguides is described. Devices were fabricated at a silicon photonics foundry using a process flow associated with operation in the $O$ , $C$ and $L$ bands and as such offer a solution for extended wavelength detection which is readily available. Intrinsic sensitivity is via indirect band transitions, which is enhanced by tensile strain and we postulate may be further enhanced by defects which arise from the thermal processes associated with Ge on Si growth. The responsivity of $p \text{-} i \text{-} n$ detectors is 20 mA/W at 1850 nm falling to 5 mA/W at 2000 nm, for a detector length of 50μm. Responsivity is suppressed by electrical doping in the germanium detector which provides parasitic absorption from free carriers. Modifications to the current design are suggested such that integrated germanium $p \text{-} i \text{-} n$ detectors, directly grown on silicon waveguides would be suitable for high-bandwidth photo-detection up to at least a wavelength of 2000 nm. A Separate-Absorption-Charge-Multiplication Avalanche Photo-Detector is fabricated exploiting the same indirect transition. This detector has a responsivity of 0.31 A/W at 1850 nm and 0.08 A/W at 1970 nm, for a detector length of only 14μm.
20 May 2020 in Optics Express
We demonstrate a silicon-on-insulator micro-ring resonator (MRR) modulator and defect-mediated (DM) detector operating at a wavelength near 2 µm for use in the thulium doped fiber amplifier wavelength band. The MRR modulator was critically coupled with an unbiased notch-depth of 20 dB and Q-factor of 4700. The resonance shift under reverse bias was 23 pm/V with a calculated VπLπ of 2.2 to 2.6 V·cm from -1 to -8 V, respectively. Simulations are in good agreement with the measured data. The experimental modulation bandwidth was 12.5 GHz, limited by the response of the commercial external detector used for this measurement. The DM detector was operated in avalanche mode, had 1.97 µm wavelength responsivities of 0.04 and 0.14 A/W, and had bandwidths greater than 16 and 7.5 GHz at -15 and -30 V biases, respectively. Large-signal measurement demonstrated open eye-diagrams at 5, 10, and 12.5 Gbps for the DM detector and also for an optical link consisting of the modulator and detector integrated on the same silicon chip.
8 July 2019 in IEEE Photonics Technology Letters
We report post-fabrication trimming of silicon-on-insulator micro-ring resonators via annealing of lattice defects using integrated micro-heaters. Defects are introduced via an inert MeV boron ion implantation at doses ranging from 3×1010 to 3×1013 cm-2. Ion implantation results in a stable red-shift ranging from 20 to 1200 pm, for the stated dose range. Post-implantation annealing produces a subsequent blue-shift ranging from 380 to 800 pm, dependent on the implantation dose, indicating partial recovery of the silicon lattice through removal of the implantation-induced defects. Evidence is shown also for a resonance blue-shift associated with modification of the micro-ring, even without a prior ion implantation step. With the method described in this work we demonstrate precise trimming of a four-ring filter such that the resonances are separated by 50 GHz, despite the as-fabricated rings having a random resonance separation resulting from fabrication variances.
5 June 2020 in Optics Express
We report on the design, fabrication and characterization of subwavelength grating metamaterial waveguides coated with tellurium oxide. The structures are first fabricated using a standard CMOS compatible process on a silicon-on-insulator platform. Amorphous tellurium oxide top cladding material is then deposited via post-process RF magnetron sputtering. The photonic bandstructure is controlled by adjustment of the device geometry, opening a wide range of operating regimes, including subwavelength propagation, slow light and the photonic bandgap, for various wavelength bands within the 1550 nm telecommunications window. Propagation loss of 1.0 ± 0.1 dB/mm is reported for the tellurium oxide-cladded device, compared to 1.5 ± 0.1 dB/mm propagation loss reported for the silicon dioxide-cladded reference structure. This is the first time that a high-index (n > 2) oxide cladding has been demonstrated for subwavelength grating metamaterial waveguides, thus introducing a new material platform for on-chip integrated optics.